Laserfiche WebLink
(4) All shrubs and groundcover areas shall be highly <br /> detailed weekly. At no time shall any dead leaves, flowers <br /> or branches exist. The contactor shall remove/prune plant <br /> material by hand using hand shears or loppers leaving no <br /> stubs. The intent is to prune the plant material without the <br /> average lay person noticing the cuts. <br /> (5) All trees below 15' shall be pruned monthly using hand <br /> shears and loppers. The intent is to prune the plant material <br /> without the average lay person noticing the cuts. <br /> (6) All grandstand bleachers shall be inspected daily and if <br /> necessary wiped clean so they are free of dirt, stains, <br /> markings, etc. <br /> Note: 30 day start-up period for Civic Center and Stadium begins on December 1, <br /> 2009 and ends February 28, 2009. <br /> Synthetic Turf Maintenance Specification <br /> Introduction <br /> This specification shall explain the procedures necessary for maintaining the synthetic <br /> <br /> turf fields at the Santa Ana Stadium and the Centennial Park, Dan Young Soccer <br /> Complex. <br /> <br /> I. Cleaning and Stain Removal <br /> A. General Dirt <br /> Rain is a natural field cleaner. Rainfall cleans the turf fibers of dust, pollen and <br /> airborne chemicals. In areas where rain is not sufficient enough to remove <br /> embedded dirt, the Contractor shall saturate the surface of the synthetic turf field <br /> until contaminants are flushed through the turf. Embedded dirt shall not be <br /> removed by mechanically sweeping the field. <br /> B. Rubbish <br /> 1. Rubbish Removal <br /> Paper, peanut shells, sunflower seeds, athletic tape, paper, etc., shall be removed <br /> daily from the synthetic turf surface. <br /> A sweeper is satisfactory for lifting paper scraps, food debris and loose trash from <br /> the surface as well. Sweeping the field should be accomplished as soon as <br /> possible after an event. The sweeper should have synthetic fiber bristles such as <br /> nylon or polyolefin. The minimum brush length should be 2.0". <br /> 25A-6 <br /> <br />