Laserfiche WebLink
<br /> <br /> <br /> <br /> <br /> 1.17 Power wash liquids should be applied to the surface at minimum water temperature of 250 degree <br /> Fahrenheit. Power wash shall be applied to the various surfaces at an operating pressure of 3500 <br /> PSI. <br /> <br /> 1.18 Cleaning chemicals used in the performance of the work activities shall be within the following <br /> OSHA Hazard Standards guidelines: <br /> <br /> 1. NFPA Hazardous Materials Identification System <br /> <br /> • Health 1 <br /> • Flammability 0 <br /> • Reactivity 0 <br /> • Contact Hazard 0 <br /> 2. Reactivity <br /> <br /> • Stable <br /> • No conditions to avoid <br /> • No incompatibility <br /> • No hazardous decomposition or by-products <br /> • No hazardous polymerization <br /> <br /> 1.19 Submittals shall include data on equipment, materials, methods, experience of personnel, Material <br /> safety Data Sheets (MSDS), certification of OSHA required training, data generated during <br /> completion of contract activities, including but not limited to analytical results, methodologies, <br /> chain of custody documentation, health and safety plan, waste management plan, storm water <br /> inlet management plan and any other information required as part of this project. <br /> 1.20 As part of the Best Management Practice included within a Storm-water Pollution Prevention <br /> Program required at a regulated facility by the NPDES permit of the Clean Water Act, no <br /> discharges will be allowed into the storm drain system or any type drain system. Appropriate cost <br /> for circumvention of the storm drain system discharges are assumed incorporated in the bid. <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> 25E-23 <br />