My WebLink
|
Help
|
About
|
Sign Out
Home
Browse
Search
11A - 2ND READ ORDINANCE - BUILDING CODES
Clerk
>
Agenda Packets / Staff Reports
>
City Council (2004 - Present)
>
2013
>
11/18/2013
>
11A - 2ND READ ORDINANCE - BUILDING CODES
Metadata
Thumbnails
Annotations
Entry Properties
Last modified
11/15/2013 6:59:20 AM
Creation date
11/15/2013 6:53:00 AM
Metadata
Fields
Template:
City Clerk
Doc Type
Agenda Packet
Agency
Planning & Building
Item #
11A
Date
11/18/2013
Destruction Year
2018
There are no annotations on this page.
Document management portal powered by Laserfiche WebLink 9 © 1998-2015
Laserfiche.
All rights reserved.
/
70
PDF
Print
Pages to print
Enter page numbers and/or page ranges separated by commas. For example, 1,3,5-12.
After downloading, print the document using a PDF reader (e.g. Adobe Reader).
View images
View plain text
10.3.6.2 All bolted joint accessories shall be cleaned and thoroughly coated with <br />asphalt or other corrosion - retarding material, prior to poly -tube, and after <br />installation. <br />Exception: Bolted joint accessories made from 304 or 316 stainless steel. <br />(f) Section 10.3.6.3 is hereby added as follows: <br />10.3.6.3 All bolts used in pipe -joint assembly shall be 316 stainless steel. <br />(g) Section 10.6.3.1 is hereby deleted and replaced as follows: <br />10.6.3.1 Where fire service mains enter the building adjacent to the foundation, <br />the pipe may run under a building to a maximum of 24 inches, as measured from <br />the interior face of the exterior wall to the center of the vertical pipe. The pipe <br />under the building or building foundation shall be 304 or 316 stainless steel and <br />shall not contain mechanical joints or it shall comply with 10.6.2. <br />(h) Section 10.6.4 is hereby revised as follows: <br />10.6.4 Pipe joints shall not be located under foundation footings. The pipe under <br />the building or building foundation shall be 304 or 316 stainless steel and shall <br />not contain mechanical joints. <br />SECTION 23: That section 8 -290 of the Santa Ana Municipal Code is hereby amended <br />such that it reads as follows: <br />Sec. 8 -290. Adoption by reference. <br />There is adopted by the city that certain code known as the California Plumbing <br />Code, 2013 Edition, including the following appendices thereto: A, B, D, I and K, <br />(hereinafter referred to in this article as the "Plumbing Code "), together with subsequent <br />supplements or amendments, which shall become effective, adopted and incorporated <br />by reference into this Code on the date specified by the state building standards <br />commission, unless otherwise specified. The plumbing code is adopted and <br />incorporated by reference as fully set forth at length herein as provided for in section <br />419 of the Charter of the city, except for the changes to the plumbing code set forth in <br />this chapter of this Code that specifically amend the plumbing code. Any previously <br />enacted, unrepealed provision of this Code that amended a pre -2013 edition of the <br />"Plumbing Code" shall also be construed as amending the applicable provision of the <br />2013 or later edition of the plumbing code. The plumbing code as amended, together <br />with all other provisions of this article, shall be known as the city plumbing code. <br />SECTION 24: That section 8 -342 of the Santa Ana Municipal Code is hereby amended <br />such that it reads as follows: <br />Sec. 8 -342. Suspended piping support (California Plumbing Code, Table 313.1). <br />Ordinance No. NS -XXXX <br />11A-19 Page 17 of 67 <br />
The URL can be used to link to this page
Your browser does not support the video tag.