Laserfiche WebLink
8,6 Selective removal of limbs obstructing buildings or other structures or traffic signs. <br />Generally, limbs closer than five (5) feet to a building or other structure should be <br />removed unless doing so would severely damage a tree, <br />8.7 Clear trees of sprout or sucker growth to a minimum height of eight (8) feet above ground <br />level. Exceptions are allowed for young trees, which would be irreparably damaged by <br />such pruning action. <br />9.0 POWER LINE CLEARANCE (PLC) PRUNING SPECIFICATIONS <br />When trees are in the proximity of overhead energized lines and equipment, reliability of service, <br />safety, and governmental standards require a reasonable amount of tree pruning to avoid <br />conductor contacts and grounding of circuits through the trees. Power Iine clearance pruning, <br />therefore, shall consist of the removal of tree branches for proper electric line clearance in order <br />to minimize the likelihood of power outages and improve safety, <br />Specifically, trees shall be pruned in such a manner as to: <br />9.1 Clear all branches and foliage within ten (10) feet of primary electrical lines. <br />9.2 Clear all branches that interfere with secondary electric lines within three (3) to five (5) <br />feet. <br />93 Protect current tree health, condition and symmetry using Dr, Alex Shigo's book, Pruning <br />Trees Near Electric Utility Lines as a guide. <br />During the tree pruning process, all safe minimum working distances for energized conductors <br />shall be observed. These clearances are defined under ANSI Z133.1 -1994, Current ANSI <br />specifications will supersede these requirements when they take effect. Any contact with <br />energized lines shall be promptly reported to an authorized SAPRF representative. <br />Access to backyards must be closely coordinated with the property owner, whenever feasible. <br />Spikes may be used for PLC pruning on palms or other trees only when needed for proper safety <br />reasons. <br />10.0 PALM PRUNING SPECIFICATIONS <br />Palms shall be pruned at the 10:00 and 2 :00 o'clock positions. Pahn pruning shall consist of the <br />pruning of the following, but not limited to, palms (Syagrus romanzoffiamun (queen palm), <br />Archontophoenix cunninghamiana (Icing palm), Phoenix Canariensis (Canary Island date palm), <br />Phoenix Dactylifera (date palm), Washingtonia filifera (California fan pahn); and Washingtonia <br />Robusta (Mexican fan palm) per these specifications. <br />10.1 The removal of all dead fronds and other dead plant parts from the trunk. All loose Bond <br />sheaths shall be removed along the entire length of the palm trunk, <br />10.2 The shaping of the palms "pineapple" beneath the fronds to achieve a consistent and <br />aesthetic appearance, <br />10.3 The removal of all flowers and frult parts whether dead or alive, <br />