Laserfiche WebLink
3. As service - entrance cable <br />4. In any nonresidential building or structure <br />5. In theatres and similar locations except where — permitted its <br />518:4{@) <br />6. In motion picture studios <br />7. In storage battery rooms <br />8. In hoist ways or on elevators or escalators <br />9. Embedded in poured cement, concrete, or aggregate. <br />10. In hazardous (classified) locations, except where specifically <br />permitted by other articles in this Code. <br />(B) Types NM and NMS. Types NM and NMS cables shall not be <br />installed In the following: <br />1. Where exposed to corrosive fumes or vapors <br />2. Where embedded in masonry, concrete, adobe, fill, or plaster <br />3. In a shallow chase in masonry, concrete, or adobe and covered <br />with plaster, adobe, or similar finish <br />4. In wet or damp locations <br />SECTION 11 Section 8 -912 of the Santa Ana Municipal Code is hereby added <br />such that it reads as follows: <br />Secs 8_868 _ B -912 Reserved. <br />Secs. 8 -868 — 8.911, Reserved. <br />Sec. 8 -912, Wiring Methods. <br />Section 230.43 of the California Electrical Code is amended to read as follows: <br />230.43 Wiring Methods for 1000 Volts Nominal or Less. Service entrance <br />conductors shall be installed in accordance with the applicable requirements of <br />this Code covering the type of wiring method used and shall be limited to the <br />following methods: <br />Ordinance No. NS -XXXX <br />Page 7 of 51 <br />75A -31 <br />