Laserfiche WebLink
Worker Aerial Lift SpecialistO requires candidates to demonstrate their ability to perform <br />as a competent aerial Iift operator. The knowledge gained with this certification can <br />improve the productivity, quality of care, and safety practices of those who earn the <br />credential. Along with proven knowledge of CPR and first aid, candidates have been <br />tested on safety procedures, and must be able to complete thorough truck and tree <br />inspection, <br />5.0 SPECIFIC TREE PRUNING SPECIFICATIONS <br />5.1 All persons performing tree work on SAPRF trees must be trained according to tree care <br />standards accepted by the International ,Society of Arboriculture. <br />5.2 All persons performing tree work on SAPRF trees in or around primary electrical fines <br />must be trained to do so according to the 'Electrical Safety Orders" of the State of <br />California, including all amendments and revisions. <br />5.3 When tree pruning cuts are made to a side limb, such remaining limb must possess a <br />basal thickness of at least one third, (1/3) of the diameter of the wound so affected. Such <br />cuts shall be considered proper only when such remaining limb is vigorous enough to <br />maintain adequate foliage to produce wood growth capable of callusing the pruning cut <br />so affected within a reasonable amount of time, <br />5.4 All final tree pruning cuts shall be made in such a manner so as to favor the earliest <br />possible covering of the wound by natural callus growth, Flash cuts, which produce large <br />wounds or weaken the tree at the cut, shall not be made. The branch collar shall not 'be <br />removed. <br />5.5 Tree limbs shall be removed and controlled in such a manner as to cause no damage to <br />Other parts of the tree, or to other plants or property. <br />5.6 All tools used on a tree known to contain an infectious tree disease shall be properly <br />disinfected immediately before and after completing work on such tree, All major <br />diseases and/or pest problems shall be promptly reported to an authorized SAPRF <br />representative, <br />5.7 All cutting tools and saws used in tree pruning shall be kept sharpened to result in final <br />cuts with smooth wood surface and secure bark remaining intact. All trees six (6) inches <br />in diameter or less shall be pruned with hand tools only, Chain saws will not be <br />pennitted on any trees six (6) inches in diameter or less. This is to prevent any <br />unnecessary abrasions to cambial tissue that may predispose a tree to insect and/or <br />disease problems. <br />5.8 Whenever pruning cuts are to be made, while removing limbs too large to hold securely <br />in one hand during the cutting operation, the limbs shall be cut off first, one (1) to two (2) <br />feet beyond the intended final cut. Then the final out shall be made in a manner to <br />prevent unnecessary tearing back of the bark and wood. Such cutting back shall not <br />include the removal of any live, healthy limbs in excess of six (6) inches in diameter <br />without prior approval fitom an authorized SAPRF representative. <br />City of Santa Ana RFP 16-126 <br />Page 51 <br />