Laserfiche WebLink
Independent laboratory tests of the carts bid must accompany bid samples certifying <br />compliance as specified in part 2 of the detailed specifications. <br />Wheels: Two (2) wheels with self-lubricating bearings with a minimum load rating of <br />120 lbs. per wheel. Wheels shall be attached to the axle via a tamper resistant snap -on <br />method which contains no metal components. No cotter pins, "Pal nuts" or similar <br />restraining devices shall be utilized to attach the wheel. All wheels shall be 1.75 inches <br />wide. Wheels shall be easily removed for replacement with a non -commercially available <br />tool. <br />Wheel Sizes: Size A: 8 inches <br />Size B: 10 inches <br />Size C: 12 inches <br />4. Axles: Axles shall be solid steel and electro -plated with black zinc for durability and long <br />life. Carts should be designed in such a way as to prevent the axle from popping out. An <br />axle, which is only press fitted and not secured in some additional manner will not be <br />acceptable. <br />Axle Sizes: Size A: 5/8 inch <br />Size B: 6/8 inch <br />Size C: 7/8 inch <br />Lids: Lids shall be molded of the same material as the cart body and shall be permanently <br />attached to the cart body with plastic hinge(s). Metal fasteners are not acceptable. Lids <br />shall be watertight and slightly domed to facilitate run-off of rainwater. The lid shall be <br />designed to fold over parallel to the back side of the cart when fully opened. Lids shall be <br />factory assembled. <br />6. Locking Bar: The semi -automated lifting area shall be integrally molded with the body of <br />the cart. The locking bar shall be able to rotate a full three -hundred sixty (360) degrees <br />and shall be constructed of zinc -coated steel to prevent rust and corrosion, Plastic locking <br />bars are unacceptable. <br />Certification by a certified independent laboratory shall be required of the following <br />minimum standards and quality assurance measurements: <br />7.1 Drop Impact Test - material and weight shall be cold soaked at a temperature of <br />not less than -20 F for 24 hours and dropped within 60 seconds of leaving the cold <br />chamber. Carts shall remain watertight after a minimum drop height of 15 feet. <br />Test loads are as follows: <br />Size A: 120 lbs. distributed <br />Size B: 160 lbs. distributed <br />Size C: 180 lbs. distributed <br />7.2 Lift and Dump Test - shall verify the cart's compatibility with approved, <br />commercially available, standard dumping equipment. Test shall be performed at <br />253-52 <br />