Laserfiche WebLink
,^-SANTA <br />ANA <br />ILIINC <br />IBiltDt\[ <br />icil0 <br />Planning E Building Agency <br />Building Safety Division <br />20 Civic Center Plaza <br />P.O. aox 1988 (M-19) <br />Santa Ana, CI.92702 <br />(714) 647-5800 <br />www.santa-ana.org <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />sol-01 cBC 2013 <br />Solar Photovoltaic (PV) Checklist for Detached SINGLE FAMILY RESIDENCES Only <br />lnstructions: The licensed contractor of record shall complete all sections, answer the ten questions and <br />sign the certification section below. A copy of this form shall be attached to each of TWO sets of plans, of <br />minimum 11" x 17" size lf answerinq NO to anv of the q uestions. Dlan check shall be required. <br />Proj ectAddtess: flO {o^*t - ))e rrn is <}c..*\J)e q.+ <br />1 <br />Contractor Company Name: <br />Contractor License Number: <br />YES NO <br />Etr <br />Fo <br />Eo <br />4( t ttl <br />Are the following applicable to the proposed project? <br />Will the PV system layout provide the required three-foot wide clear access pathways <br />per Section 605.11 of the California Fire Code, and is this shown on the roof plan? <br />Will the PV system be installed on a roof having only one roofing layer with no <br />overlays? <br />Will the PV affay be flush mounted to the existing roof so that the plane of the <br />modules (panels) are parallel to the plane of the roof? <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Will the PV system be installed where the modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will the PV system be installed with a space of 2" minimum to 10" maximum between <br />the underside of modules and the surface of the roof? <br />Will the PV system be installed without using any ballast system or counter-weight <br />system? <br />Will the anchors be installed with a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Wll the minimum 5/16" lag screws be installed with a minimum of 2-112 inch <br />embedment into roof rafters (with pre-drilled holes) and is this minimum embedment <br />shown on the plans? <br />Are ALL the structural pages of the plans WET stamped and signed by a California <br />licensed professional engineer? (including project specific site plan, PV layout, <br />anchorage spacing, anchorage details and manufacturer's PV support information.) <br />I certify under penalty of periury under the laws of the State of Cal at is true: <br />Print Name: 0. 6t oA 0'NE Signature: <br />Date: J <br />2 <br />3 <br />4 <br />5 <br />6sEo <br />M <br />o Eltr <br />, Etr <br />s. Eltr <br />g Altr <br />10 tr <br />o <br />PhoneNumber: 0G( qlq ?OL{t <br />Email Address O NlJ L/O <br />Rev 811712015 <br />Oo r.t