Laserfiche WebLink
*-SANTA <br />ANA-"'i}.To <br />Plannlng & Bulldlng Agency <br />Buildlng Slfsty Divislon <br />20 Clvlc Conter Plaze <br />P.O. Box 1988 (M.19) <br />Santa Ana, CA 92702 <br />(714) 6/t7-s800 <br />www.santa€na.org <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />- <br />sol-01 cBc 2013 <br />Solar Photovoltalc (PV) Checktist tor Detached STNGLE FAMtLy RESTDENCES Onty <br />lnstructlons: Th€ licensed contractor of record shall complete all sections, answer the ten questions and <br />sign the certification section below. A copy of this form shall be attachod to each of TWO sets of plans. of <br />minimum '11" x 17" size. lf answsrin NO to anv of the ouesti ons. plan check shall be required. <br />Project Aadressl 5420 W FLIGHT AVE, SANTA ANA, CA92704 <br />Contractor Comp <br />Contractor Llcens" *rr*r, <br />YES <br />1.8 <br />2.8 <br />3.8 <br />4.EI <br />5.El <br />6E <br />7.8 <br />8.8 <br />e. El <br />10. El <br />NO <br />D <br />D <br />tr <br />tr <br />tr <br />tr <br />tr <br />tr <br />tr <br />tr <br />Are the followlng appllcable to the proposod prorect? <br />Will the PV systsm layout provide lhe required three-foot wide clear accsss pathways <br />per Section 605.1'l of the Califomia Fire Code, and is this shown on the roof plan? <br />Will the PV system be installed on a roof having only one roofing layer with no <br />overlays? <br />Will tho PV anay b€ flush mounted to the exisling rool so that lho plane of the <br />modules (panels) are parall€l lo lhe plane of the roof? <br />Will the PV system waigh maximum 4 pounds per square feet or less? <br />Will the PV system be installed where ths modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will the PV system bs installod with a space of 2" minimum to 10" maximum between <br />the underside of modules and the surfac€ of the roof? <br />Will the PV system bs inslalled without using any ballast system or counter-weight <br />system? <br />Will the anchors be installed with a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Will the minimum 5/16' lag screws be installsd with a minimum of 2-1l2 inch <br />emb€dment into roof rafters (with pre-drilled hol6s) and is this minimum emb€dment <br />shown on lhe plans? <br />Are ALL the slructural pages of the plans WET stamped and signed by a California <br />licensed professlonal engineer? (includlng project specific site plan, pV layout, <br />anchorage spacing, anchorage d8tails and manufactur€/s PV support information.) <br />Signature <br />Date: <br />I certlfy under penalty of periury under lhe laws ot the State of C ifornla lhat the above is true: <br />pdnlN6mg. TRANG CONG PHAM <br />phone Number: 714 582 3909 <br />Ema ir Address: PERMIT@SOUTHWESTSUNSOLAR.COM <br />Rov:8/1712015