Laserfiche WebLink
,,-SANTA <br />NA <br />[$\nc <br />uulJr\-G <br />$Nil <br />Planning & Building Agency <br />Building Salery Divisi'on <br />20 Civic Center Plaza <br />P.O. Box 1988 (M-19) <br />Santa Ana, CA 92702 <br />(714) 647-s8(x' <br />www.santa-ana.org <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />sol-01 cBc 20 13 <br />Solar Photovoltaic (PV) Checklist for Detached SINGLE FAMILY RESIDENCES Only <br />lnstructions: The licensed contractor of record shall complete all sections, answer the ten questions and <br />sign the certilication section below. A copy of this form shall be attached to each of TWO sets ol plans, of <br />minimum 11" x 17" size. lf answerino NO anv of the ouestions. Dl an check shall be required. <br />Project Address:\.ittr rtll [-n <br />C1r )Contractor Company Name: <br />Contractor License Number: <br />YES NO <br />2 <br />3 <br />4 <br />Fa <br />Fa <br />,da <br />Fa <br />.da <br />aa <br />EJ <br />,o fiJ <br />tr <br />tr <br />n <br />,a <br />Are the following applicable to the proposed prolect? <br />Will the PV system layout provide the required three-foot wide clear access pathways <br />per Section 605.11 ol the California Fire Code, and is this shown on the roof plan? <br />Will the PV system be installed on a roof having only one roofing layer with no <br />overlays? <br />Will the PV array be flush mounted to the existing roof so that the plane of the <br />modules (panels) are parallel to the plane of the roof? <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Will the PV system be installed where the modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will the PV system be installed with a space of 2" minimum lo l0" maximum between <br />lhe underside of modules and the surface of the roof? <br />Will the PV system be installed without using any ballast system or counter-weight <br />system? <br />Will the anchors be installed with a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Will the minimum 5/16" lag screws be installed with a minimum ol 2-112 i^ch <br />embedment into rool rafters (with pre-drilled holes) and is this minimum embedment <br />shown on the plans? <br />Are ALL the struclural pages ol the plans stamped and signed by a California <br />licensed prolessional engineer? (including proiect specific site plan, PV layout, <br />anchorage spacing, anchorage details and manufaclurer's PV support information.) <br />6 <br />7 <br />8 <br />I <br />I certify under pe <br />Print Name: <br />'A1,ifi"alTi?li laws of the State ol Calilorn <br />Signature: <br />Date:Phone Number: <br />Email Address: <br />Rev: 11/19/2015 <br />Cl aLe rrtv 3 <br />at the above is t.ue: <br />n^ <br />/ <br />I *