Laserfiche WebLink
,,^-SANTA <br />NA <br />tlr\utc <br />t8[LD[\G <br />tctril <br />Planning & Building Agency <br />Building Safety Division <br />20 Civic Center Plaza <br />P.O. Box 1988 (M-19) <br />Santa Ana, CA 92702 <br />(714) 647-s800 <br />www,santa-ana.org <br />RESIDENTIAL <br />PHOTOVOLTA!C <br />CHECKLIST <br />Solar Photovoltaic (PV) Checklist for Detached SINGLE FAMILY RESIDENCES Only <br />ans wer the len questions andlnstructions: The licensed contractor of record shall complete all section <br />sign the certification section below. A copy of this form shall be attached <br />minimum 11" x 17" size. lf answerin NO to an of the uestions la <br />S <br />Project Address: <br />Contractor Company Name: <br />Contractor License Number: <br />4a <br />o <br />Signat <br />Date: <br />) <br />4 <br />F tr <br />tr <br />tr <br />tr <br />tr <br />tr <br />trtr <br />trtr <br />,a <br />E <br />,D <br />d <br />D <br />c tr10 <br />3 <br />I certify und <br />Print Name: <br />YES- No Are the following applicable to the proposed project? <br />Will the PV system layout provide the requlred three-foot wide clear access pathways <br />per Section 605.11 of the California Fire Code, and is this shown on the roof plan? <br />Will the PV system be installed on a roof having only one roofing layer with no <br />overlays? <br />Will the PV array be flush mounted to the existing roof so that the plane of the <br />modules (panels) are parallel to the plane of the roof? <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Will the PV system be installed where the modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will the PV system be installed with a space of 2" minimum to 10" maximum between <br />the underside of modules and the surface of the roof? <br />Will the PV system be installed without using any ballast system or counter-weight <br />system? <br />Will the anchors be installed with a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Will the minimum 5/16" lag screws be installed with a minimum of 2-112 tnch <br />embedment into roof rafters (with pre-drilled holes) and is this minlmum embedment <br />shown on the plans? <br />Are ALL the slructural pages of the plans stamped and signed by a California <br />licensed professional engineer? (including project specific site plan, PV layout, <br />anchorage spacing, anchorage details and manufacturer's PV support information.) <br />6 <br />7 <br />8 <br />9 <br />er nalty of perjury u nder the laws of the State of California that the above is true,,fu%-Z/,4 ureoz-Phone Number <br />Email Address:a <br />eac o <br />check s <br />Rev 11/19/2015 <br />/t <br />( <br />a <br />.,.,2 <br />sol{l cBC 2013 <br />4 <br />7