Laserfiche WebLink
*,,SANTA <br />NA-"'iiltr <br />Planning & Building Agency <br />Building Safety Division <br />20 Civic Center Plaza <br />P.O. Box '1988 (M-19) <br />Santa Ana, CA92702 <br />(714) 647.5800 <br />www.santa-ana.org <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKL!ST <br />sol-01 c8c 2013 <br />Solar Photovoltaic (PV) Checklist for Detached STNGLE FAMtLy RESTDENCES Onty <br />lnstructions: The licensed contractor of record shall complete all sections, answer the ten questions and <br />sign the certification section below. A copy of this form shall be attached to each of TWO sets of plans, of <br />minimum 1 1" x '17' size. lf answerinq NO to an v of the questions. D lan check shall be required. <br />Contractor Company Name: <br />Contractor License Number: <br />.'l <br />4 <br />5 <br />2 <br />3 <br />6 <br />7 <br />8 <br />YES NOtrtr <br />Etr <br />Ettr <br />Etr <br />trtr <br />Eltr <br />Etr <br />tstr <br />trtr <br />?ss R <br />Are the following applicable to the proposed project? <br />Will the PV system layout provide the required three-foot wide clear access pathways <br />per Section 605.11 of the California Fire Code, and is this shown on the roof plan? <br />Will the PV system be lnstalled on a roof having only one roofing layer with no <br />overlays? <br />Will the PV array be flush mounted to the existing roof so that the plane of the <br />modules (panels) are parallel to the plane of the roof? <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Will the PV system be installed where the modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will the PV system be installed with a space of 2" minimum to 10" maximum between <br />the underside of modules and the surface of the roof? <br />Will the PV system be installed without using any ballast system or counter-weight <br />system? <br />Will the anchors be installed with a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Will the minimum 5/16" lag screws be installed with a minimum of 2-'l12 inch <br />embedment into roof raflers (with pre{rilled holes) and is this minimum embedment <br />shown on the plans? <br />Are ALL the structural pages of the plans stamped and signed by a California <br />I <br />10 otr <br />licensed professional engineer? (including <br />anchorage spacing, anchorage details and <br />EC ific pla n PV layout,proJ <br />a tion.) <br />I certify under penalty of perlury under the laws of th <br />Print Name: 7+"- llxus,onl <br />e State of alifor <br />S ig natu r <br />Date:5-lt7lt7Phone Number: AZb) 7or =3r8o <br />Email Address <br />Rev'11/1S/2015 <br />?e"l-ar-t1T^l Zeeo L.> . <-o <br />true <br />ProjectAddress: ZisZG &<en/ 6rza,.€ * S*17 An/A f+ 4ZZO<-