Laserfiche WebLink
,-,,SANTA <br />NA,',rffi[t <br />Planning & Building Agency <br />Building Safety Division <br />20 Civic Center Plaza <br />P.O. Box 1988 (M-19) <br />Santa Ana, CA 92702 <br />(714) 647-5800 <br />www.santa{na-org <br />RES!DENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />soL"01 cBc 2013 <br />Solar Photovoltaic (PV) Checklist for Detached SINGLE FAMTLY RESTOENCES Only <br />lnstructions: The licensed contractor of record shall complete all sections, answer lhe ten questions and <br />sign the certification seclion below. A copy of this form shall be attached to each of TWO sets of plans, of <br />minimum 1 1" x 17" size. ll ^n swerina! N Otoan of the uestion s itlan cha ck shall be reo uired <br />Project Address 4509 SUNSWEPT AVE, SANTA ANA, CA 92703 <br />SOUTHWEST SUN SOLAR, INC <br />contractorLicenseNumber: 1004667 <br />YES NO Aie the following applicable to the proposed project? <br />Will the PV system layout provide the required three-foot wide clear access pathways <br />per Seclion 605.1 1 of the Califomia Fire Code, and is this shown on the roof plan? <br />Will the PV system be installed on a roof having only one roofing layer with no <br />overlays? <br />Will the PV array be flush mounted to the existing roof so that the plane of the <br />modules (panels) are parallel to the plane of the roof? <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Will the PV system be installed where the modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will the PV system be installed with a space of 2" minimum to 10" maximum between <br />the underside of modules and the surface of the roof? <br />Will the PV system be installed without using any ballast system or counter-weight <br />system? <br />Will the anchors be installed with a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Will the minimum 5/16" lag screws be installed with a minimum of 2-112 inch <br />embedment inlo roof rafters (wilh pre-drilled holes) and is this minimum embedment <br />shown on lhe plans? <br />Are ALL lhe structural pages of the plans WET stamped and signed by a Califomia <br />licensed professional engineer? (including project specific site plan, PV layout, <br />anchorage spacing, anchorage details and manufacture/s PV support information.) <br />tr tr <br />?Etr <br />Eltr <br />Ettr <br />Etr <br />Etr <br />Etr <br />4 <br />5 <br />6 <br />7 <br />I Etr <br />9. Etr <br />10 Etr <br />I cerlify under penalty of perjury under the laws of the State of California th <br />Print Name. TRANG CONG PHAIVI <br />phone Number: 714 582 3909 <br />Signature: <br />Date: <br />Email Addres <br />Rev: 8/1712015 <br />S: PERI\4IT@SOUTHWESTSUNSOLAR.COT\'4 <br />tg <br />Contraclor Company Name: <br />is true: