Laserfiche WebLink
Rapid Shutdown Kit - Installation and Configuration (Single Phase Inverters) <br />Rapid Shutdown Kit Installation - MAN-01-00186-1.6 2 <br />5 The rapid shutdown cables have a resistor connected to one end (on the red cable). Connect these ends to the switch, <br />making sure that the red and black cables are reversed relative to the cables connected at the top of the switch (going into <br />the DC side conduit between the inverter and the Safety Switch), as detailed below. Apply a torque of 2 N*m (18 lb*in): <br /> If the cables at the top are red and black from left to right, connect as shown below. <br />Figure 2: Rapid shutdown cable connected – option 1 <br />If the cables at the top are black and red from left to right, connect as shown below. <br /> <br />Figure 3: Rapid shutdown cable connected – option 2 <br />6 Use a standard straight-bladed screwdriver to connect the other end of the rapid shutdown cables to the DC connection <br />spring-clamp terminals: Connect the black cable from the switch to the DC- terminal block, and connect the red cable from <br />the switch to the DC+ terminal block. <br />7 Check that the cables are located and connected in the correct positions to ensure the rapid shutdown functionality. <br />8 Close the cover: Attach the switch cover and secure it by tightening the four screws with a torque of 0.9 ft.*lb / 1.2 N*m. <br />Red (+) Black (-) <br />Black (-) <br />DC+ DC- <br />Red (+) with rapid <br />shutdown resistor <br />Black (-) Red (+) <br />Black (-)Red (+) with rapid <br />shutdown resistor <br />DC+ DC- <br />723 S Orange Ave <br />03/14/22