Laserfiche WebLink
ELECTRICAL NOTES: <br />E8 <br />SHEET NUMBER: <br />SE <br />M <br />P <br />E <br />R <br /> <br />S <br />O <br />L <br />A <br />R <br />I <br />S <br />1 <br />8 <br />0 <br />5 <br /> <br />J <br />O <br />H <br />N <br /> <br />T <br />O <br />W <br />E <br />R <br />S <br /> <br />A <br />V <br />E <br />EL <br /> <br />C <br />A <br />J <br />O <br />N <br />, <br /> <br />C <br />A <br /> <br />9 <br />2 <br />0 <br />2 <br />0 <br />C- <br />1 <br />0 <br /> <br />L <br />I <br />C <br /> <br /># <br /> <br />9 <br />7 <br />8 <br />1 <br />5 <br />2 <br />Li <br />c <br />. <br /> <br />H <br />o <br />l <br />d <br />e <br />r <br /> <br />D <br />i <br />g <br />i <br />t <br />a <br />l <br />l <br />y <br /> <br />S <br />t <br />a <br />m <br />p <br />e <br />d <br />PR <br />O <br />J <br />E <br />C <br />T <br /> <br />F <br />O <br />R <br />: <br />PR <br />O <br />P <br />O <br />S <br />E <br />D <br />DRAWN BY: <br />DATE: <br />(DC) kW: <br />PROJECT #: <br />Jo <br />h <br />n <br /> <br />A <br />l <br />m <br />o <br />n <br />d <br />ENPH DESIGN <br />01-02-2023 <br />79275 <br />5.60 <br />PE <br />T <br />E <br /> <br />M <br /> <br />A <br />B <br />A <br />S <br />C <br />A <br />L <br />SA <br />N <br />T <br />A <br /> <br />A <br />N <br />A <br /> <br />C <br />A <br /> <br />9 <br />2 <br />7 <br />0 <br />7 <br />61 <br />3 <br /> <br />W <br /> <br />B <br />E <br />L <br />L <br /> <br />A <br />V <br />E <br />(7 <br />1 <br />4 <br />) <br /> <br />8 <br />6 <br />5 <br />- <br />0 <br />4 <br />6 <br />6 <br />41 <br />0 <br />1 <br />9 <br />5 <br />0 <br />6 <br />SO <br />L <br />A <br />R <br /> <br />P <br />H <br />O <br />T <br />O <br />V <br />O <br />L <br />T <br />A <br />I <br />C <br />SY <br />S <br />T <br />E <br />M <br /> <br />S <br />I <br />Z <br />E <br />: <br />5. <br />6 <br />0 <br /> <br />k <br />W <br /> <br />D <br />C <br /> <br />P <br />V <br />CIRCUIT RELOCATION CALCULATION <br />1) ALL MODULES WILL BE GROUNDED IN <br />ACCORDANCE WITH CODE AND THE <br />MANUFACTURER’S INSTALLATION <br />INSTRUCTIONS. <br />2) ALL PV EQUIPMENT SHALL BE LISTED BY A <br />RECOGNIZED TESTED LAB. <br />3) NOTIFY SERVING UTILITY BEFORE ACTIVATION <br />OF PV SYSTEM. <br />4) WHEN A BACKFED BREAKER IS THE METHOD OF <br />UTILITY INTERCONNECTION, BREAKER SHALL <br />NOT READ LINE AND LOAD. <br />5) WHEN A BACKFED BREAKER IS THE METHOD OF <br />UTILITY INTERCONNECTION, THE BREAKER <br />SHALL BE INSTALLED AT THE OPPOSITE END OF <br />THE BUS BAR OF THE MAIN BREAKER. <br />6) WORKING SPACE FOR EQUIPMENT OPERATING <br />AT 1000 VOLTS, NOMINAL, OR LESS TO GROUND <br />AND LIKELY TO REQUIRE EXAMINATION, <br />ADJUSTMENT, SERVICING, OR MAINTENANCE <br />WHILE ENERGIZED SHALL COMPLY WITH [CEC <br />110.26(A)] <br />7) ALL EXTERIOR CONDUITS, FITTINGS AND BOXES <br />SHALL BE RAIN-TIGHT AND APPROVED FOR USE <br />IN WET LOCATIONS PER [CEC 314.15]. <br />8) ALL METALLIC RACEWAYS AND EQUIPMENT <br />SHALL BE BONDED AND ELECTRICALLY <br />CONTINUOUS. <br />9) PV EQUIPMENT, SYSTEMS AND ALL ASSOCIATED <br />WIRING AND INTERCONNECTIONS SHALL ONLY <br />BE INSTALLED BY QUALIFIED PERSONS. [CEC <br />690.4 (C)]. <br />10) THE PHOTOVOLTAIC SYSTEM CONDUCTORS <br />SHALL BE IDENTIFIED AND GROUPED. THE <br />MEANS OF IDENTIFICATION SHALL BE <br />PERMITTED BY SEPARATED COLOR CODING, <br />MARKING TAPE, TAGGING OR OTHER APPROVED <br />MEANS. [CEC 690.31(B)(1)] <br />11) ADEQUATE SPACING MUST BE MAINTAINED <br />BETWEEN ANY PLUMBING SEWER VENTS <br />EXTENDING THROUGH THE ROOF AND THE <br />UNDERSIDE OF THE PHOTOVOLTAIC PANELS (6" <br />MINIMUM RECOMMENDED). <br />613 W Bell Ave <br />03/20/23