Laserfiche WebLink
www.hilti.com <br />Hilti PROFIS Engineering 3.1.1 <br />Input data and results must be checked for conformity with the existing conditions and for plausibility! <br />PROFIS Engineering ( c ) 2003-2024 Hilti AG, FL-9494 Schaan Hilti is a registered Trademark of Hilti AG, Schaan <br />10 <br />Company: <br />Address: <br />Phone I Fax: <br />Design: <br />Fastening point: <br /> | <br />Depal - Anchorage Design <br />Page: <br />Specifier: <br />E-Mail: <br />Date: <br />10 <br />7/19/2024 <br />Coordinates Anchor [in.] <br />Anchor x y c-x c+x c-y c+y <br />1 -3.750 -1.750 30.000 35.500 30.000 35.500 <br />2 1.750 3.750 35.500 30.000 35.500 30.000 <br />7 Installation data <br /> Anchor type and diameter: HIT-HY 200 V3 + HAS-V-36 <br /> (ASTM F1554 Gr.36) 3/4 <br /> Profile: no profile Item number: 2198030 HAS-V-36 3/4"x10" (element) / <br /> 2334276 HIT-HY 200-R V3 (adhesive) <br /> Hole diameter in the fixture: df = 0.812 in. Maximum installation torque: 100.000 ft.lb <br /> Plate thickness (input): 1.250 in. Hole diameter in the base material: 0.875 in. <br /> Recommended plate thickness: not calculated Hole depth in the base material: 7.000 in. <br /> Drilling method: Hammer drilled Minimum thickness of the base material: 8.750 in. <br /> Cleaning: Compressed air cleaning of the drilled hole according to instructions <br /> for use is required <br /> Hilti HAS threaded rod with HIT-HY 200 V3 injection mortar with 7 in embedment hef, 3/4, Carbon steel, Safe Set System, Hammer drilled <br /> installation per ESR-4868 <br />7.1 Recommended accessories <br />Drilling Cleaning Setting <br />• Suitable Rotary Hammer <br />• Properly sized drill bit <br />• Compressed air with required accessories <br /> to blow from the bottom of the hole <br />• Proper diameter wire brush <br />• Dispenser including cassette and mixer <br />• Torque wrench <br />1995 S Standard Ave- <br />Concrete Pads10/15/2024