Laserfiche WebLink
*-SANTA <br />NA <br />PL$][tG <br />&ttjlilrc <br />lfi]Icl <br />Planning & Building Agency <br />Building Safety Division <br />20 Civic Center Plaza <br />P.O. Box 1988 (M-19) <br />Santa Ana, CA 92702 <br />(714) 647-5800 <br />www.santa-ana.or9 <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />Solar Photovoltaic (PV) Checklist for Detached SINGLE FAMILY RESIDENCES Only <br />lnstructions: The licensed contractor of record shall complete all sections, answer the ten questions and <br />sign the certiflcation section below. A copy of this form shall be attached to each of TWO sets of plans, of <br />minimum 11" x 17" size. lf answerinq NO to anv of the questions, plan check shall be required. <br />Project Address:2315 N. Riverside Ave. Santa Ana 9270 6 <br />Contractor Company Name: Pure Solar <br />ContractorLicenseNumber: 1006423 <br />YES NO <br />Eltr <br />Eltr <br />EID <br />gtrgtr <br />Eltr <br />1 <br />2 <br />o <br />7 <br />4 <br />Are the following applicable to the proposed project? <br />Will the PV system layout provide the required three-foot wide clear access pathways <br />per Section 605.1 1 of the California Fire Code, and is this shown on the roof plan? <br />Will the PV system be installed on a roof having only one roofing layer with no <br />overlays? <br />Will the PV array be flush mounted to the existing roof so that the plane of the <br />modules (panels) are parallel to the plane of the roof? <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Will the PV system be installed where the modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will the PV system be installed with a space of 2" minimum to 10" maximum between <br />the underside of modules and the surface of the roof? <br />Will the PV system be installed without using any ballast system or counter-weight <br />system? <br />Will the anchors be installed with a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Wll the minimum 5/16" lag screws be installed with a minimum of 2-112 inch <br />embedment into roof rafters (with pre-drilled holes) and is this minimum embedment <br />shown on the plans? <br />Are ALL the structural pages of the plans stamped and signed by a California <br />licensed professional engineer? (including project specific site plan, PV layout, <br />anchorage spacing, anchorage details and manufacturer's PV support information.) <br />I <br />Eltr <br />gtr <br />Uu <br />10 gtr <br />Email Address: ash ley @ pu resolarpros.com <br />sol-01 cBc 2013 <br />o <br />I certify under penalty of periury under the laws of the State of California that the above is true: <br />Print Name: David Valadez Signature: :+zt7-- <br />Phone Number: 951-426-4602 Date: 5/30/18