Laserfiche WebLink
*,,SNTA <br />NAffi <br />Planning & Building Agency <br />Building Safety Oivision <br />20 Civic Center Plaza <br />P.O. Box 1988 (M-19) <br />Santa Ana, CA 92702 <br />(714) 647.5800 <br />www.santa-ana.org <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />sol-01 cBc 2013 <br />Solar Photovoltaic (PV) Checklist for Detached SINGLE FAMILY RESIDENCES Only <br />lnstructions: The licensed contractor of record shall complete all sections, answer the ten questions and <br />sign the certification section below. A copy of this form shall be attached to each of TWO sets of plans, of <br />minimum 11'' x 17" slze. lf answerinq NO to anv of the ouestion s. Dlan check shall be required. <br />Project Address: <br />'zt --2L <br />Contractor Company Name: <br />Contractor License Number: <br />YES NO <br />qtqffiz_ <br />Are the following applicable to the proposed project? <br />Will the PV system layout provlde the required three-foot wide clear access pathways <br />per Section 605.11 of the California Fire Code, and is this shown on the roof plan? <br />Will the PV system be installed on a roof having only one roofing layer with no <br />overlays? <br />Will the PV array be flush mounted to the existing roof so that the plane of the <br />modules (panels) are parallel to the plane of the roof? <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Will the PV system be installed where the modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will the PV system be installed with a space of 2" minimum to l0" maximum between <br />the underside of moduies and the surface of the roof? <br />Will the PV system be installed without using any ballast system or counter-weight <br />system? <br />Will the anchors be installed with a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Will the minimum 5/16" lag screws be installed with a minimum of 2-112 inch <br />embedment into roof rafters (with pre-drilled holes) and is this minimum embedment <br />shown on the plans? <br />Are ALL the structural pages of the plans stamped and signed by a California <br />licensed professional engineer? (including project specific site plan, PV layout, <br />anchorage spacing, anchorage details and manufacturer's PV support information.) <br />F-_tr <br />Rtr <br />F-E <br />Fa <br />Atfu <br />ffio <br />tr <br />Phone Number <br />Email Address: <br />I certify under jury und er the laws of the State of Ca <br />Print Name <br />of per <br />+o Signa <br />Date: <br />Rev 11/19/2015 <br />nalty <br />.1*ture <br />rnia that the a s true: <br />1 <br />2 <br />3. <br />4. <br />5 <br />6. <br />7. <br />8. <br />9. <br />10.