Laserfiche WebLink
Planning & Building Agency <br />Building Safety Oivision <br />20 Civic Center Plaza <br />P.O. Box 1988 (M-l9) <br />Santa Ana. CA 92702 <br />(714) 647.5800 <br />www.santa-ana.org <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKL!ST <br />sol-01 cBC 2013 <br />Solar Photovoltaic (PV) Checklast for Detached SINGLE FAMILY RESIDENCES Only <br />lnstructions: The licensed contractor of record shall complete all sections, answer the ten questions and <br />sign the certification section below. A copy of this form shall be attached to each of TWO sets of plans, of <br />minimum 11" x 17" size. lf answerinq NO anv of the ouestions. Dlan check s hall be reouired. <br />Project Address: <br />3tLI ,.2L g. <br />Contractor Company Name: <br />Contractor License Number: <br />F-_tr <br />Ftr <br />F-o <br />"N <br />' FlJr <br />UKtr <br />,pn <br />,OF€ <br />2 <br />3 <br />q)qffi?_ <br />Are the following applicable to the proposed proiect? <br />Will the PV system layout provide the required three-foot wide clear access pathways <br />per Section 605.11 of the California Fire Code, and is this shown on the roof plan? <br />Will the PV system be installed on a roof having only one roofing layer with no <br />overlays? <br />Will the PV array be flush mounted to the existing roof so that the plane of the <br />modules (panels) are parallel to the plane of the roof? <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Will the PV system be installed where the modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will the PV system be installed with a space of 2" minimum to 10" maximum between <br />the underside of modules and the surface of the roof? <br />Will the PV system be installed without using any ballast system or counter-weight <br />system? <br />Will the anchors be installed with a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Will the minimum 5/'16" lag screws be installed with a minimum of 2-112 inch <br />embedment into roof rafters (with pre-drilled holes) and is this minimum embedment <br />shown on the plans? <br />Are ALL the structural pages of the plans stamped and signed by a California <br />licensed professional engineer? (including project speciflc site plan, PV layout, <br />anchorage spacing, anchorage details and manufacturer's PV support information.) <br />lcertify under nalty of perjury under the laws of the State of Ca <br />4 <br />5 <br />Phone Number <br />Email Address: <br />"-7 <br />k, <br />"1*Date <br />nia that the ab is true: <br />**SNTA <br />NA'ffi <br />1 <br />YES NO <br />Print Name:Signature: <br />Rev: 11/19/2015