Laserfiche WebLink
*,,SANTA <br />NA,"Tffi <br />Planning E Bullding Agency <br />Building Satoty Divislon <br />20 Clvlc Csnter Plaza <br />P.O. Box '1988 (M-19) <br />Santa Ana, CA 92702 <br />(714) 547.5800 <br />www.santa-ana.org <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />sol-01 CBC 2013 <br />Solar Photovoltaic (PV) Checktist for Detached STNGLE FAMtLy RESTDENCES Onty <br />lnslructlons: The licensed contractor of record shall complete all sections, answer the ten questions and <br />sign the certification section below. A copy of this form shall be attached to each of TWO s ets of plans, of <br />minimum '11" x 17" size. lf answo rinq NO to anv of the ouestions. Dlan check shall be re q u ired. <br />Project Adarees; 2601 LAIRD ST' SANTA ANA, CA 92706 <br />Contractor Company Name: <br />Contractor License Number: <br />SOUTHWEST SUN SOLAR, INC <br />1004667 <br />YES NO Ai6 the following appllcable to the propossd project? <br />Will the PV system layout provide the rsquired three-foot wide clear access pathways <br />per Section 605.1 1 of tho Califomia Fire Code, and is this shown on the roof plan? <br />Will the PV system bs installed on a roof having only one roofing layer with no <br />overjays? <br />Will the PV anay be flush mounted to the existing roof so that the plane of the <br />modules (panels) are parallel to the plane of th6 roof? <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Will ths PV system be installed where the modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will the PV system be inslallod with a space of 2" minimum to 10" maximum between <br />the underside o, modules and the surfacs of the roof? <br />Will the PV system be installed without using any balast system or counter-weight <br />sYStem? <br />Will the anchors bs installed with a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Will the minimum 5/16" lag screws bs installed with a minimum of 2-112 inch <br />embedmsnt into roof raners (with pre-drilled holes) and is this minimum embedment <br />shown on the plans? <br />Are ALL the structural pages of the plans WET stamped and signed by a California <br />a tr <br />Ettr <br />I tso <br />10 Efl <br />licensed professional engineer? (including project specific site plan, PV I <br />anchorage spacing, anchorage details and manufaclurs/s pV suppo rmation.) <br />I certify under penalty ot periury undor the laws ot lhe State of California that bove is true: <br />4 <br />5 <br />2 <br />3 <br />6 <br />7 <br />I <br />trD <br />Eto <br />Etr <br />Ettr <br />Etr <br />ao <br />pr;61 x3mg. TRANG CONG PHAM <br />phone Number: 7'14 582 3909 <br />Signature <br />Date: <br />Emait Address: PERMIT <br />Rev:811712O15 <br />@SoUTHWESTSUNSOLAR.COM <br />e <br />2 /E