Laserfiche WebLink
1,® <br />Installing the <br />M215 Microinverter (M215-60) <br />Read and follow all warnings and instructions in the M215 Installation and Operation Manual at <br />http://www.enphase.com/support before installing the M215 Microinverter™. <br />Install the Envoy Communications Gateway <br />Install according to the steps in the Envoy Quick /nsta# Guide.EnvoyLeave the Envoy running while you install the microinverters so broadband <br />that any required Envoy software upgrade completes.(+03 touter <br />00.000 <br />0/0.00 <br />Warning: Do not remove power from <br />the Envoy if the LCD displays: <br />"Upgrading. . . Do Not Unplug." <br />AC power <br />COFd <br />lai <br />Ethernet cable <br />Position the Enphase EngageTM Cable <br />a. Lay out the cabling along the installed racking for <br />the AC branch circuit. <br />terminator - <br />b. Install an appropriately rated, off-the-shelf junction <br />box at a suitable location on the racking./5»431 /,·ga»·t_-2--·474:d;LI>--<p« Engage CableSee notes in St€ - '--'-'- - - ' <br />drop connector <br />AC junction box <br />p Deans on oacK. <br />0 <br />000 cable ties <br />connects to drop <br />connectors <br />M215 <br />Hill -*>DC connectors <br />h.21Ur#*-3 <br />Check the drop connector labels to <br />be sure that you have the right cable. <br />You must use 240 VAC cable for single phase <br />or 208 VAC cable for three-phase. <br />un