Laserfiche WebLink
M215 Microinverter Quick install Guide <br />e Attach the Microinverters to the PV Racking <br />a. Mark the approximate centers of each PV <br />module on the PV racking. See notes in <br />Step Deta#s on back. <br />?C$ <br />0 Dress the Cable <br />a. Attach the cabling to the rack using <br />cable clips or tie wraps <br />b. Dress any excess cabling in loops so that <br />it does not contact the root. <br />cable clip <br />release holes <br />Keep the drop <br />connector <br />release holes K **i,V <br />b. Mount the microinverters under the PV module,clear and L. -2 6 <br />away from rain and sun. Do not mount the accessible. 'r <br />microinverter in a position that allows long-term <br />exposure to direct sunlight or in a vertical orientation <br />that allows water to collect in the DC connector <br />recess. <br />c. Torque the microinverter fasteners as follows: <br />• 5Nm (45-50 in-lbs) for 6mm (1/4") hardware <br />• 9Nm (80-85 in-lbs) for 8mm (5/16") hardware <br />0 Connect the Microinverters <br />a. Remove and discard the temporary shipping <br />cap from the cable connector and connect the <br />microinverter. Usten for two clicks as the <br />connectors engage. <br />0 Ground the System <br />a. Route a continuous GEC (grounding electrode <br />conductor) through each of the microinverters to <br />the NEC-approved AC grounding electrode. , <br />See notes in Step Details on back. <br />b. Torque each 10/32 grounding cleat screw to <br />2 N m (20-25 in-lbs).-1 <br />GEC <br />3 It <br />, 1 <br />'0 1 <br />3__ <br />b. Cover any unused connectors with sealing <br />caps. Listen for two clicks as the connectors <br />engage. See notesin Step Details on back. <br />U \ <br />grounding <br />cleat <br />Do not use shipping caps to cover <br />unused connectors. The shipping cap <br />does not provide an adequate <br />environmental seal. <br />0