Laserfiche WebLink
Installation Instructions with Compression Bracket <br />•0396(219-453•F#04 <br />L <br />1 2 <br />1. Locate the rafters and snap horizontal and vertical lines to mark the <br />installation position for each flashing. <br />2. Drill a pilot hole (1/4"diameter) for the lag bolt. Backfill with sealant. <br />3. Insert the flashing so the top part is under the next row of shingles <br />and pushed far enough up slope to prevent water infiltration through/ vertical joint in shingles. <br />4. Line up pilot hole with flashing hole. <br />Insert the lag bolt through the EPDM washer, the top compression <br />component (Comp Slide 4" Bracket pictured) and the gasketed hole in <br />the flashing and into the rafter. <br />6. Torque: The range is between 100-140 torque inch-pounds depending <br />on the type of wood and time of year. The visual indicator for proper <br />torque is when the EPDM on the underside of the bonded washer <br />5 6 impact wrench to install the fasteners be careful not to over torque thebegins to push out the sides as the washer compresses. If using an <br />\ <br />fastener. You may need to stop and use a ratchet to finish the install. <br />877-859-3947 Committed to the Support of Renewable Energy © Ecofasten Solar- All content protected under copyright All rights reserved 04/8/14