Laserfiche WebLink
400 Sunrise Ave., Suite 270 <br />Roseville, CA 95661 <br />916.755.3571 / MiTek-US.com <br />Design valid for use only with MiTek® connectors. This design is based only upon parameters shown, and is for an individual building component, not <br />a truss system. Before use, the building designer must verify the applicability of design parameters and properly incorporate this design into the overall <br />building design. Bracing indicated is to prevent buckling of individual truss web and/or chord members only. Additional temporary and permanent bracing <br />is always required for stability and to prevent collapse with possible personal injury and property damage. For general guidance regarding the <br />fabrication, storage, delivery, erection and bracing of trusses and truss systems, see ANSI/TPI1 Quality Criteria and DSB-22 available from Truss Plate Institute (www.tpinst.org) <br />BCSI Building Component Safety Information <br />WARNING - Verify design parameters and READ NOTES ON THIS AND INCLUDED MITEK REFERENCE PAGE MII-7473 rev. 1/2/2023 BEFORE USE. <br />and available from the Structural Building Component Association (www.sbcscomponents.com) <br />SCAB-BRACE DETAIL <br />Scab-Brace must be same species grade (or better) as web member. <br />MII-SCAB-BRACE <br />SCAB BRACE <br />Section Detail <br />Scab-Brace <br />Web <br />Nails <br />APPLY 2x___ SCAB TO ONE FACE OF WEB WITH <br />2 ROWS OF 10d (0.131" X 3") NAILS SPACED 6" O.C. <br />SCAB MUST BE THE SAME GRADE, SIZE AND <br />SPECIES (OR BETTER) AS THE WEB. <br />MAXIMUM WEB AXIAL FORCE = 2500 lbs <br />MAXIMUM WEB LENGTH = 12'-0" <br />2x4 MINIMUM WEB SIZE <br />MINIMUM WEB GRADE OF #3 <br />Note: Scab-Bracing to be used when continuous <br /> lateral bracing at midpoint (or T-Brace) is <br /> impractical. <br /> Scab must cover full length of web +/- 6". <br />*** THIS DETAIL IS NOT APLICABLE WHEN BRACING IS *** <br /> REQUIRED AT 1/3 POINTS OR I-BRACE IS SPECIFIED. <br />MiTek USA, Inc.Page 1 of 1 <br />A MiTek Affiliate <br />ENGINEERED BY <br />SEPTEMBER 1, 2021 <br />December 19,2024