Laserfiche WebLink
M215 Microinverter Quick Install Guide <br />0 Position the Enphase Engage Cable <br />Lay out the cable along the installed racking.0 Ground the Microinverters <br />Ground the microinverters using either the <br />grounding lug with a continuous ground wire <br />or WEEB grounding washers. See notes in <br />Step Detai/s on back. <br />continuous <br />ground . <br />.. <br />Check the drop <br />connector labels to <br />be sure that you have <br />the right cable. <br />You must use 240 Vac <br />cable for single phase <br />or 208 Vac cable for <br />grounding 1 ,gs::t | <br />three-phase. <br />/ug <br />0 Attach the Microinverters to the PV Racking <br />a. Mark the approximate centers of each PV <br />module on the PV racking. See notes in <br />Step Detai/s on back. <br />0 Dress the Cable <br />a. Attach the cabling to the rack using the <br />cable clips, or you may use tie wraps. <br />cable clip <br />release holes <br />b. Mount the microinverters with the silver side <br />facing up and the black side facing down.Keep the drop connector release <br />holes clear and accessible. <br />b. Dress any excess cabling in loops so that <br />it does not contact the roof.