Laserfiche WebLink
Connect the Microinverters <br />a. Remove the red temporary shipping cap from <br />the cable connector and connect the micro-...%,finverter. Listen for two clicks as the connectors <br />engage. <br />b. Slide the hex nut onto the cable. <br />c. Insert the cable end all the way into the <br />wire organizer (up to the stop). <br />hex wire <br />nut organizer cap <br />1 1 <br />8 IJ <br />1 \\ <br />b. Cover any unused connectors with sealing <br />caps. Listen for two clicks as the connectors <br />engage. See notes in Step Detai/s on back. <br />d. Attach the cap. <br />bend wires down <br />. into recesses of <br />wire organizer and <br />trim to /ength <br />191 <br />Do not use the <br />red shipping cap to <br />cover unused <br />connectors. The <br />shipping cap does <br />not provide an <br />adequate <br />environmental seal. <br />lu <br />0 <br />\ place cap over <br />the wire organizer <br />&61- 9 hold the cap with <br />A 1--the disconnect <br />tool or a #2 <br />screwdriver <br />/ rotate the hex- nut with your <br />hand or a wrench <br />unti/ the /atching <br />mechanism meets <br />the base - do not <br />overtorque <br />e. Attach the terminated cable end to the rack- <br />ing with a clip or tie wrap. <br />Terminate the Unused End of the Cable <br />a. Remove 70mm (3") of the cable sheath from <br />the conductors. <br />Connect the Cable to the AC Junction Box <br />Connect the cable into the AC branch circuit <br />junction box. See notes in Step Detai/s on back.