Laserfiche WebLink
Guardian Fall Protection <br /> 6305 S. 231st St., Kent, WA 98032 phone: (800) 466- <br />6385 fax: (800) 670 <br />-7892 <br /> www.guardianfall.com <br />5 <br />All installation of CB-18 Anchors MUST be approved by a Competent or <br />Qualified Person, or by a Guardian Fall Protection certified installer.!WARNING <br />3/4” min. <br />All fasteners fully <br />embedded in substrate <br />*Sample profile shown only <br />Installation and Use <br />Prior to use, plan your system: <br />1. Ensure all PFAS equipment is selected and deemed compatible with CB-18 by a Competent Person. <br />2. Eliminate or minimize all risk of swing fall. <br />3. Ensure structure to which CB-18 is to be installed, and on which work is to be performed, is free of all <br />hazards, including, but not limited to, debris, rot, rust, sharp or abrasive edges and surfaces, and hazardous <br />materials. <br />4. A Qualified Person must determine that structure to which CB-18 is to be installed is rated to withstand <br />minimum required loads. There are no minimum or maximum spacing requirements for CB-18 Anchors, <br />provided structure is of sufficient strength. <br />5. For all CB-18 Anchors, all applicable fastener holes MUST be used and all fasteners MUST be fully embedded <br />in substrate. NEVER over-tighten fasteners. <br />6. CB-18 is rated for loading in any direction provided it is installed as prescribed. Suitable for use in HLL <br />applications. <br />MINIMUM substrate thickness requirements: <br />• Wood: 3/4” CDX. <br />• Metal: 18 gauge, or 20 gauge if reinforced with <br />CB Spanner Plate (part # 00604, contact Guardian <br />for more information). <br />• Concrete: 6”, 2,500 psi or better. <br />Substrate fastener requirements: <br />• Wood: #14 x 10, 2” wood deck screws. Qty. 60. <br />• Metal: #14 x 14, 2” metal deck screws. Qty. 60. <br />Please note that longer screws may be required in order <br />to achieve the minimum necessary substrate <br />penetration. All fasteners must penetrate metal decking <br />by at least ¼”. <br />• Concrete: ½” x 3” concrete bolts. Qty. 8. <br />CB-18 roof slope compatibility: flat - sheer. Any installation past sheer (for example, on the <br />underside of a beam) must be done in combination with backer plate. <br />Installation, CB-18 <br />Wood Install (part #s 00654, 00657, and 00659): <br />MINIMUM substrate requirement: 3/4” thick CDX. <br />1. Place CB-18 at selected installation location. <br />2. Install all (60) fasteners until snug, and ensure CB-18 is <br />fully secured to substrate. <br />3. All fasteners MUST be fully embedded in wood decking.