Laserfiche WebLink
Welding must <br />be done by AWS <br />certified welder <br />Maintenance, Cleaning, and Storage <br />If CB-18 fails inspection in any way, immediately remove it from service, and contact Guardian to inquire <br />about its return or repair. Field serviceability testing is not required, and should not be done by the end user. <br />Cleaning after use is important for maintaining the safety and longevity of CB-18. Remove all dirt, corrosives, <br />and contaminants from CB-18 before and after each use. If CB-18 cannot be cleaned with plain water, use mild <br />soap and water, then rinse and wipe dry. NEVER clean CB-18 with corrosive substances. <br />When not in use, store equipment where it will not be affected by heat, light, excessive moisture, chemicals, <br />or other degrading elements. <br /> Guardian Fall Protection <br /> 6305 S. 231st St., Kent, WA 98032 phone: (800) 466- <br />6385 fax: (800) 670 <br />-7892 <br /> www.guardianfall.com <br />7 <br />Installation, CB-18 Weld-On (part # 10652, 10655, and 10656) <br />CB-18 Weld-On Post must be installed by an American Welding Society (AWS) certified welder in <br />accordance with all applicable welding regulations. <br />Post diameter: 2 7/8” <br />Fillet weld: 5/16” <br />Minimum beam flange width: 3½”