Laserfiche WebLink
Round 1 Bowling and Amusement 12/09/2024 Paradigm Design <br />Main Place Mall Expansion Grand Rapids, MI <br />Santa Ana, California <br />Project #2309147GR <br />ALUMINUM-FRAMED ENTRANCES AND STOREFRONTS 08 4113 - 6 <br />ed. 2024-02-20 <br />1.Outdoor-Indoor Transmission Class: Minimum 26. <br />J.Thermal Movements: Allow for thermal movements resulting from ambient and surface temperature <br />changes. <br />1.Temperature Change: 120 deg F, ambient; 180 deg F, material surfaces. <br />2.Thermal Cycling: No buckling; stress on glass; sealant failure; excess stress on framing, <br />anchors, and fasteners; or reduction of performance when tested in accordance with <br />AAMA 501.5. <br />a.High Exterior Ambient-Air Temperature: That which produces an exterior metal-surface <br />temperature of 180 deg F. <br />b.Low Exterior Ambient-Air Temperature: 0 deg F. <br />c.Interior Ambient-Air Temperature: 75 deg F. <br />2.3 ALUMINUM-FRAMED ENTRANCE AND STOREFRONT SYSTEMS (EXTERIOR) <br />A.Basis-of-Design Product: Subject to compliance with requirements, provide Tubelite Inc.; TU24000 <br />Series Storefront Framing, 2″ x 4-1/2″ profile, and Therml=Block Entrances or a comparable product <br />by one of the following: <br />1.EFCO Corporation. <br />2.Kawneer Company, Inc.; Arconic Corporation. <br />3.OldCastle BuildingEnvelope (OBE). <br />4.YKK AP America Inc. <br />B.Framing Members: Manufacturer's extruded- or formed-aluminum framing members of thickness <br />required and reinforced as required to support imposed loads. <br />1.Exterior Framing Construction: Thermally broken. <br />2.Glazing System: Retained mechanically with gaskets on four sides. <br />3.Glazing Plane: Center. <br />4.Finish: <br />a.Standard clear anodic finish, unless otherwise specified on Drawings. <br />b.Optional color anodic finish. Refer to Drawings for color. <br />5.Fabrication Method: Field-fabricated stick system. <br />6.Aluminum: Alloy and temper recommended by manufacturer for type of use and finish <br />indicated. <br />7.Steel Reinforcement: As required by manufacturer. <br />C.Backer Plates: Manufacturer's standard, continuous backer plates for framing members, if not integral, <br />where framing abuts adjacent construction. <br />D.Brackets and Reinforcements: Manufacturer's standard high-strength aluminum with nonstaining, <br />nonferrous shims for aligning system components.