Laserfiche WebLink
Round 1 Bowling and Amusement 12/09/2024 Paradigm Design <br />Main Place Mall Expansion Grand Rapids, MI <br />Santa Ana, California <br />Project #2309147GR <br />ALUMINUM-FRAMED ENTRANCES AND STOREFRONTS 08 4113 - 10 <br />ed. 2024-02-20 <br />6.Fasteners, anchors, and connection devices that are concealed from view to greatest extent <br />possible. <br />C.Mechanically Glazed Framing Members: Fabricate for flush glazing without projecting stops. <br />D.Entrance Door Frames: Reinforce as required to support loads imposed by door operation and for <br />installing entrance door hardware. <br />1.At interior and exterior doors, provide compression weather stripping at fixed stops. <br />E.Entrance Doors: Reinforce doors as required for installing entrance door hardware. <br />1.At pairs of exterior doors, provide sliding-type weather stripping retained in adjustable strip and <br />mortised into door edge. <br />2.At exterior doors, provide weather sweeps applied to door bottoms. <br />F.Entrance Door Hardware Installation: Factory install entrance door hardware to the greatest extent <br />possible. Cut, drill, and tap for factory-installed entrance door hardware before applying finishes. <br />G.After fabrication, clearly mark components to identify their locations in Project in accordance with <br />Shop Drawings. <br />2.10 ALUMINUM FINISHES <br />A.Standard Clear Anodic Finish: AAMA 611, AA-M12C22A41, Class I, 0.018 mm or thicker, unless <br />otherwise specified on Drawings. <br />B.Optional Color Anodic Finish: AAMA 611, AA-M12C22A42/A44, Class I, 0.018 mm or thicker. <br />Refer to Drawings for color. <br />PART 3 - EXECUTION <br />3.1 EXAMINATION <br />A.Examine areas, with Installer present, for compliance with requirements for installation tolerances and <br />other conditions affecting performance of the Work. <br />B.Proceed with installation only after unsatisfactory conditions have been corrected. <br />3.2 INSTALLATION OF ALUMINUM-FRAMED ENTRANCE AND STOREFRONT SYSTEMS <br />A.Comply with manufacturer's written instructions. <br />B.Do not install damaged components.