Laserfiche WebLink
Round 1 Bowling and Amusement 12/09/2024 Paradigm Design <br />Main Place Mall Expansion Grand Rapids, MI <br />Santa Ana, California <br />Project #2309147GR <br />ALUMINUM-FRAMED ENTRANCES AND STOREFRONTS 08 4113 - 9 <br />ed. 2024-02-20 <br />1.Structural Shapes, Plates, and Bars: ASTM A36/A36M. <br />2.Cold-Rolled Sheet and Strip: ASTM A1008/A1008M. <br />3.Hot-Rolled Sheet and Strip: ASTM A1011/A1011M. <br />E.Steel Reinforcement Primer: Manufacturer's standard zinc-rich, corrosion-resistant primer complying <br />with SSPC-PS Guide No. 12.00; applied immediately after surface preparation and pretreatment. Select <br />surface preparation methods in accordance with recommendations in SSPC-SP COM, and prepare <br />surfaces in accordance with applicable SSPC standard. <br />2.8 ACCESSORIES <br />A.Fasteners and Accessories: Manufacturer's standard corrosion-resistant, nonstaining, nonbleeding <br />fasteners and accessories compatible with adjacent materials. <br />1.Use self-locking devices where fasteners are subject to loosening or turning out from thermal <br />and structural movements, wind loads, or vibration. <br />2.Reinforce members as required to receive fastener threads. <br />3.Use exposed fasteners with countersunk Phillips screw heads, finished to match framing system. <br />B.Anchors: Three-way adjustable anchors with minimum adjustment of 1 inch that accommodate <br />fabrication and installation tolerances in material and finish compatible with adjoining materials and <br />recommended by manufacturer. <br />1.Concrete and Masonry Inserts: Hot-dip galvanized cast-iron, malleable-iron, or steel inserts <br />complying with ASTM A123/A123M or ASTM A153/A153M requirements. <br />C.Concealed Flashing: Manufacturer's standard corrosion-resistant, nonstaining, nonbleeding flashing <br />compatible with adjacent materials. <br />D.Bituminous Paint: Cold-applied asphalt-mastic paint containing no asbestos, formulated for 30-mil <br />thickness per coat. <br />E.Rigid PVC filler. <br />2.9 FABRICATION <br />A.Form or extrude aluminum shapes before finishing. <br />B.Fabricate components that, when assembled, have the following characteristics: <br />1.Profiles that are sharp, straight, and free of defects or deformations. <br />2.Accurately fitted joints with ends coped or mitered. <br />3.Physical and thermal isolation of glazing from framing members. <br />4.Accommodations for thermal and mechanical movements of glazing and framing to maintain <br />required glazing edge clearances. <br />5.Provisions for field replacement of glazing from exterior.