Laserfiche WebLink
Round 1 Bowling and Amusement 12/09/2024 Paradigm Design <br />Main Place Mall Expansion Grand Rapids, MI <br />Santa Ana, California <br />Project #2309147GR <br />EXTERIOR PAINTING 09 9113 - 3 <br />1.Materials for use within each paint system shall be compatible with one another and substrates <br />indicated, under conditions of service and application as demonstrated by manufacturer, based on <br />testing and field experience. <br />2.For each coat in a paint system, products shall be recommended in writing by topcoat manufacturers for <br />use in paint system and on substrate indicated. <br />C.Colors: As indicated in a color schedule. <br />PART 3 - EXECUTION <br />3.1 EXAMINATION <br />A.Examine substrates and conditions, with Applicator present, for compliance with requirements for maximum <br />moisture content and other conditions affecting performance of the Work. <br />B.Maximum Moisture Content of Substrates: When measured with an electronic moisture meter as follows: <br />1.Concrete: 12 percent. <br />C.Portland Cement Plaster Substrates: Verify that plaster is fully cured. <br />D.Verify suitability of substrates, including surface conditions and compatibility, with existing finishes and <br />primers. <br />E.Proceed with coating application only after unsatisfactory conditions have been corrected. <br />1.Application of coating indicates acceptance of surfaces and conditions. <br />3.2 PREPARATION <br />A.Comply with manufacturer's written instructions and recommendations in "MPI Architectural Painting <br />Specification Manual" applicable to substrates and paint systems indicated. <br />B.Remove hardware, covers, plates, and similar items already in place that are removable and are not to be <br />painted. If removal is impractical or impossible because of size or weight of item, provide surface-applied <br />protection before surface preparation and painting. <br />1.After completing painting operations, use workers skilled in the trades involved to reinstall items that <br />were removed. Remove surface-applied protection. <br />C.Clean substrates of substances that could impair bond of paints, including dust, dirt, oil, grease, and <br />incompatible paints and encapsulants. <br />1.Remove incompatible primers and reprime substrate with compatible primers or apply tie coat as <br />required to produce paint systems indicated.