Laserfiche WebLink
Round 1 Bowling and Amusement 12/09/2024 Paradigm Design <br />Main Place Mall Expansion Grand Rapids, MI <br />Santa Ana, California <br />Project #2309147GR <br />c.Measure room temperature at each thermostat/temperature sensor. Compare the <br />reading to the set point. <br />d.Verify that balancing devices are marked with final balance position. <br />e.Note deviations from the Contract Documents in the final report. <br />B.Final Inspection: <br />1.After initial inspection is complete and documentation by random checks verifies that <br />testing and balancing are complete and accurately documented in the final report, request <br />that a final inspection be made by Architect. <br />2.Architect shall randomly select measurements, documented in the final report, to be <br />rechecked. Rechecking shall be limited to either 10 percent of the total measurements <br />recorded or the extent of measurements that can be accomplished in a normal 8-hour <br />business day. <br />3.If rechecks yield measurements that differ from the measurements documented in the <br />final report by more than the tolerances allowed, the measurements shall be noted as <br />"FAILED." <br />4.If the number of "FAILED" measurements is greater than 10 percent of the total <br />measurements checked during the final inspection, the testing and balancing shall be <br />considered incomplete and shall be rejected. <br />C.TAB Work will be considered defective if it does not pass final inspections. If TAB Work fails, <br />proceed as follows: <br />1.Recheck all measurements and make adjustments. Revise the final report and balancing <br />device settings to include all changes; resubmit the final report and request a second final <br />inspection. <br />2.If the second final inspection also fails, Owner may contract the services of another TAB <br />contractor to complete TAB Work according to the Contract Documents and deduct the <br />cost of the services from the original TAB contractor's final payment. <br />D.Prepare test and inspection reports. <br />3.11 ADDITIONAL TESTS <br />A.Within 90 days of completing TAB, perform additional TAB to verify that balanced conditions <br />are being maintained throughout and to correct unusual conditions. <br />B.Seasonal Periods: If initial TAB procedures were not performed during near-peak summer and <br />winter conditions, perform additional TAB during near-peak summer and winter conditions. <br />END OF SECTION 23 0593