Laserfiche WebLink
Round 1 Bowling and Amusement 12/09/2024 Paradigm Design <br />Main Place Mall Expansion Grand Rapids, MI <br />Santa Ana, California <br />Project #2309147GR <br />HVAC INSULATION 23 0700 - 15 <br />a.Avery Dennison Corporation, Specialty Tapes Division; Fasson 0800. <br />b.Other manufacturers by voluntary alternate. <br />2.Width: 2 inches. <br />3.Thickness: 3.7 mils. <br />4.Adhesion: 100 ounces force/inch in width. <br />5.Elongation: 5 percent. <br />6.Tensile Strength: 34 lbf/inch in width. <br />E.PVDC Tape for Indoor Applications: White vapor-retarder PVDC tape with acrylic adhesive. <br />1.Products: Subject to compliance with requirements, provide one of the following: <br />a.Dow Chemical Company (The); Saran 540 Vapor Retarder Tape. <br />b.Other manufacturers by voluntary alternate. <br />2.Width: 3 inches. <br />3.Film Thickness: 4 mils. <br />4.Adhesive Thickness: 1.5 mils. <br />5.Elongation at Break: 145 percent. <br />6.Tensile Strength: 55 lbf/inch in width. <br />2.10 SECUREMENTS <br />A.Bands: <br />1.Products: Subject to compliance with requirements, provide one of the following: <br />a.Childers Products; Bands. <br />b.Other manufacturers by voluntary alternates. <br />2.Stainless Steel: ASTM A 167 or ASTM A 240/A 240M, Type 304 or Type 316; 0.015 <br />inch thick, 3/4 inch wide with wing or closed seal. <br />3.Springs: Twin spring set constructed of stainless steel with ends flat and slotted to accept <br />metal bands. Spring size determined by manufacturer for application. <br />B.Insulation Pins and Hangers: <br />1.Capacitor-Discharge-Weld Pins: Copper- or zinc-coated steel pin, fully annealed for <br />capacitor-discharge welding, 0.135-inch-diameter shank, length to suit depth of insulation <br />indicated. <br />2.Cupped-Head, Capacitor-Discharge-Weld Pins: Copper- or zinc-coated steel pin, fully <br />annealed for capacitor-discharge welding, 0.135-inch-diameter shank, length to suit depth <br />of insulation indicated with integral 1-1/2-inch galvanized carbon-steel washer. <br />3.Insulation-Retaining Washers: Self-locking washers formed from 0.016-inch-thick, <br />galvanized-steel or stainless-steel sheet, with beveled edge sized as required to hold <br />insulation securely in place but not less than 1-1/2 inches in diameter. <br />C.Staples: Outward-clinching insulation staples, nominal 3/4-inch-wide, stainless steel or Monel.