505 E Central Ave #B - DEF 1 - Plan

Home Browse Search

CITY OF SANTA ANA SPECIFICATIONS PROJECT NO.: XX-XXXX PROJECT TITLE 191 If relocation requires an increase in depth or horizontal realignment of the pipe, 45˚ Bends shall be used to re-route the pipe. Thrust blocks shall be required in accordance with City of Santa Ana Standard Plan Nos. 1403A, 1403B, 1403C, and 1412. All pipe trenches shall have 6" minimum of sand bedding beneath the pipe and sand backfill over the pipe compacted to 90% relative compaction. 7.17 FIRE HYDRANT ASSEMBLY This work shall consist of furnishing and installing wet barrel fire hydrants, break away spool, check valve, spool extensions and bury assemblies in the locations indicated on the plans. Hydrant lateral pipe, gate valves and appurtenances are included as part of this work. Fire Hydrant assembly shall be installed in accordance with AWWA C502, City of Santa Ana Standard Plan Nos. 1405 and these Special Provisions. Wet barrel fire hydrant shall be Clow, Model 860. The break off check valve shall be Clow Model LBI 400A. Bury shall be ductile iron body with mechanical joint per Clow. No break away bolts will be allowed. The Contractor shall install trace wire in accordance with and per Section 7.12, Trace Wire, of these Special Provisions and City Standard Plan No. 1405. All hydrant exposed metal exterior coatings shall be in conformance with City of Santa Ana Standard Plan No. 1405, and these Special Provisions. The fire hydrant must have factory applied coating when delivered to site (i.e. must come white from factory). Fire Hydrant Coating (exposed exterior above ground)  Type- Gloss synthetic enamel white  Prime Coat: Apply a one coat, 4-mil  Finish Coat: Apply two coats of (OSHA White), 6-mil for each coat Each coat shall be applied evenly and with the use of mechanical devices. Allow sufficient time between successive coats. The use of rollers and brushes is not allowed. All ductile or cast iron pipe, fittings, valves, and appurtenances buried underground shall be encased or wrapped with 10-mil linear low-density (LLD) polyethylene film. Any existing or connecting pipe and appurtenances that are exposed as a result of this pipe installation shall also be wrapped with polyethylene sheeting. Where necessary, Contractor shall saw-cut, remove and replace sidewalk to facilitate hydrant installation. Sidewalk shall be replaced per City of Santa Ana Standard Plan No . 1104. Sidewalk replacement shall be from score line to score line, unless the sidewalk 505 E Central Ave #B11/6/2024