Laserfiche WebLink
CITY OF SANTA ANA <br />1I6-610 SEATS I P I a <br />II5-610.1 GENERAL. SEATS IN BATHTUBS AND SHOWER <br />GOMPARTMENTS SHALL GOMPLY WITH SECTION IIB-61 <br />IIB-610.2 BATHTUB SEATS. THE TOP OF BATHTUB SEA 5 SHALL <br />BE 11 INGHES (432 MM) MINIMUM AND I � INGHES (483 M) <br />MAXIMUM ABOVE THE BATHROOM FINISH FLOOR. THE EPTH <br />OF A REMOVABLE IN -TUB SEAT SHALL BE 15 INGHES (51 Ve <br />MINIMUM AND 16 INGHES (406 MM) MAXIMUM. THE SEA7 5H <br />BE GAPABLE OF 5EGURE PLAGEMENT. PERMANENT SE NT5 AT <br />THE HEAD END OF THE BATHTUB SHALL BE 15 INGHES 351 <br />MM)DEEP MINIMUM AND SHALL EXTEND FROM THE BACK WALL <br />TO OR BEYOND THE OUTER EDGE OF THE BATHTUB. <br />116-610.3 SHOWER GOMPARTMENT SEATS. A SEAT IN A M a <br />STANDARD ROLL -IN SHOWER GOMPARTMENT SHALL <br />FOLDING TYPE, SHALL BE INSTALLED ON THE SIDE W L a t <br />ADJAGENT TO THE CONTROLS, AND SHALL EXTEND FROM THE <br />BAGK WALL TO A POINT WITHIN 3 INGHE5 (76 MM) OF ITHE <br />GOMPARTMENT ENTRY. A SEAT IN AN ALTERNATE ROLL -IN <br />TYPE SHOWER GOMPARTMENT SHALL BE A FOLDING TYPE, <br />SHALL BE INSTALLED ON THE FRONT WALL OPPOSITE THE <br />BAGK WALL, AND SHALL EXTEND FROM THE ADJAGENT 51DE <br />WALL TO A POINT WITHIN 3 INGHES (16 MM) OF THE <br />GOMPARTMENT ENTRY. IN TRANSFER TYPE 5HOWER5, THE 5EA1 <br />SHALL EXTEND FROM THE BAGK WALL TO A POINT WITHIN 3 <br />INGHE5 (16 MM) OF THE GOMPARTMENT ENTRY. THE TOP OF <br />THE SEAT SHALL BE 11 INGHES (432 MM) MINIMUM AND I� <br />INGHES A53 MM) MAXIMUM ABOVE THE BATHROOM FINISH <br />FLOOR. WHEN FOLDED, THE SEAT SHALL EXTEND 6 INGHES (152 <br />MM) MAXIMUM FROM THE MOUNTING WALL. SEATS SHALL <br />GOMPLY WITH SEGTION II5-610.3.1 OR IIB-610.3.2. <br />II5-610.3.1 REGTAN6ULAR SEATS. THE REAR EDGE OF A <br />REGTAN&ULAR SEAT SHALL BE 2 1/2" INGHES (64 MM) <br />MAXIMUM AND THE FRONT EDGE 15 INGHE5 (381 MM) MINIMUM <br />AND 16 INGHES (406 MM) MAXIMUM FROM THE SEAT WALL. THE <br />SIDE EDGE OF THE SEAT SHALL BE 1 1/2" INGHES (35 MM) <br />MAXIMUM FROM THE ADJAGENT WALL. <br />II5-610.3.2 L-SHAPED SEATS. THE REAR EDGE OF AN <br />L-SHAPED SEAT SHALL BE 2 1/2" INGHES (64 MM) MAXIMUM <br />AND THE FRONT EDGE 15 INGHES (381 MM) MINIMUM AND 16 <br />INGHE5 (406 MM) MAXIMUM FROM THE SEAT WALL. THE REAR <br />E06E OF THE ©LA PORTION OF THE SEAT SHALL BE 1 1/2 11 <br />INGHES (35 MM) MAXIMUM FROM THE WALL AND THE FRONT <br />EDGE SHALL BE 14 INGHE5 (356 MM) MINIMUM AND 15 INCHES <br />(331 MM) MAXIMUM FROM THE WALL. THE END OF THE ©LA <br />SHALL BE 22 INGHE5 (551 MM) MINIMUM AND 23 INGHES (554 <br />MM) MAXIMUM FROM THE MAIN SEAT WALL. <br />IIB=610.4 5TRUGTURAL STRENGTH. ALLOWABLE STRESSES <br />SHALL NOT BE EXGEEDED FOR MATERIALS USED WHEN A <br />VERTIGAL OR HORIZONTAL FORGE OF 250 POUNDS (1112 N) 15 <br />APPLIED AT ANY POINT ON THE SEAT, FASTENER, MOUNTING <br />DEVICE, OR SUPPORTING 5TRUGTURE. <br />Ln <br />0 <br />Ui <br />w <br />O <br />z <br />Q <br />ry <br />w <br />z <br />w <br />O <br />N <br />O <br />O <br />O <br />N <br />z <br />Q <br />J <br />W <br />z <br />O <br />z <br />0 <br />0 <br />J <br />m <br />W <br />W <br />O <br />z <br />D <br />O <br />O <br />w <br />7 <br />Q <br />z <br />/ <br />Q <br />n <br />architecture & planning <br />er4a- MITCHEL_L- N. SUITE 'C' <br />IRVINE, CALIFORNIA 92614 <br />PHONE: (949) <br />FAX: (949) <br />752-1177 <br />rAIP PAKOJI S <br />©KNITTER PARTNERS INTERNATIONAL <br />ALL RIGHTS RESERVED 2025 <br />THIS DOCUMENT IS THE PROPERTY AND COPYRIGHT OF <br />KNITTER PARTNERS INTERNATIONAL, INC. AND SHALL NOT BE <br />USE ON ANY OTHER WORK, BE REPRODUCED OR DISCLOSED TO <br />OTHERS EXCEPT BY WRITTEN AUTHORIZATION FROM KNITTER <br />PARTNERS INTERNATIONAL., INC. <br />1111117ma <br />Oq-16-25 <br />InwvAI6,4E*]al <br />m <br />kn <br />O <br />N <br />m <br />PROJECT INFO <br />GENERAL <br />JOB NUMBER 24077 <br />PROJECT MGR. PB <br />DRAWN BY 5TAFF <br />PLOT DATE: 10-14-2025 <br />SHEET TITLE <br />GENERAL NOTES <br />Cy <br />SHEET NUMBER <br />