Laserfiche WebLink
ST. BARBARA CATHOLIC SCHOOL TASK 2 75-24272-01 <br />DIOCESE OF ORANGE SEPTEMBER 12TH, 2024 <br />SANTA ANA, CA BID & PERMIT SET <br /> <br />CLOSEOUT PROCEDURES 017700 - 6 <br />j. Clean transparent materials, including mirrors and glass in doors and windows. <br />Remove glazing compounds and other noticeable, vision-obscuring materials. <br />Polish mirrors and glass, taking care not to scratch surfaces. <br />k. Remove labels that are not permanent. <br />l. Wipe surfaces of mechanical and electrical equipment, elevator equipment, and <br />similar equipment. Remove excess lubrication, paint and mortar droppings, and <br />other foreign substances. <br />m. Clean plumbing fixtures to a sanitary condition, free of stains, including stains <br />resulting from water exposure. <br />n. Replace disposable air filters and clean permanent air filters. Clean exposed <br />surfaces of diffusers, registers, and grills. <br />o. Clean ducts, blowers, and coils if units were operated without filters during <br />construction or that display contamination with particulate matter on inspection. <br />p. Clean light fixtures, lamps, globes, and reflectors to function with full efficiency. <br />q. Leave Project clean and ready for occupancy. <br />C. Pest Control: Comply with pest control requirements in Section 015000 "Temporary Facilities <br />and Controls." Prepare written report. <br />D. Construction Waste Disposal: Comply with Owner waste disposal. <br />3.2 REPAIR OF THE WORK <br />A. Complete repair and restoration operations before requesting inspection for determination of <br />Substantial Completion. <br />B. Repair, or remove and replace, defective construction. Repairing includes replacing defective <br />parts, refinishing damaged surfaces, touching up with matching materials, and properly <br />adjusting operating equipment. Where damaged or worn items cannot be repaired or restored, <br />provide replacements. Remove and replace operating components that cannot be repaired. <br />Restore damaged construction and permanent facilities used during construction to specified <br />condition. <br />1. Remove and replace chipped, scratched, and broken glass, reflective surfaces, and other <br />damaged transparent materials. <br />2. Touch up and otherwise repair and restore marred or exposed finishes and surfaces. <br />Replace finishes and surfaces that that already show evidence of repair or restoration. <br />a. Do not paint over "UL" and other required labels and identification, including <br />mechanical and electrical nameplates. Remove paint applied to required labels and <br />identification. <br />3. Replace parts subject to operating conditions during construction that may impede <br />operation or reduce longevity. <br />4. Replace burned-out bulbs, bulbs noticeably dimmed by hours of use, and defective and <br />noisy starters in fluorescent and mercury vapor fixtures to comply with requirements for <br />new fixtures.