Laserfiche WebLink
ST. BARBARA CATHOLIC SCHOOL TASK 2 75-24272-01 <br />DIOCESE OF ORANGE SEPTEMBER 12TH, 2024 <br />SANTA ANA, CA BID & PERMIT SET <br /> <br />DIMENSIONAL LETTER SIGNAGE 101419 - 4 <br />2.6 GENERAL FINISH REQUIREMENTS <br />A. Protect mechanical finishes on exposed surfaces from damage by applying a strippable, temporary <br />protective covering before shipping. <br />B. Appearance of Finished Work: Noticeable variations in same piece are not acceptable. Variations <br />in appearance of adjoining components are acceptable if they are within the range of approved <br />Samples and are assembled or installed to minimize contrast. <br />C. Directional Finishes: Run grain with long dimension of each piece and perpendicular to long <br />dimension of finished trim or border surface unless otherwise indicated. <br />D. Organic, Anodic, and Chemically Produced Finishes: Apply to formed metal after fabrication but <br />before applying contrasting polished finishes on raised features unless otherwise indicated. <br />2.7 ALUMINUM FINISHES <br />A. Paint color finish: <br />1. Paints and Coatings for Sheet Materials: Inks, dyes, and paints that are recommended by <br />manufacturer for optimum adherence to surface and are UV- and water-resistant for colors <br />and exposures indicated, and as follows: <br />a. Products: Subject to compliance with requirements, provide the following or <br />approved equal: <br />1) Matthews Paint Co., Polyurethane, baked in shop for durability. <br />B. Color Anodic Finish at Contractor’s Option to Paint: AAMA 611, Class I, 0.018 mm or thicker. <br />1. As indicated on Drawings. <br />PART 3 - EXECUTION <br />3.1 EXAMINATION <br />A. Examine substrates, areas, and conditions, with Installer present, for compliance with <br />requirements for installation tolerances and other conditions affecting performance of signage <br />work. <br />B. Verify that sign-support surfaces are within tolerances to accommodate signs without gaps or <br />irregularities between backs of signs and support surfaces unless otherwise indicated. <br />C. Verify that electrical service is correctly sized and located to accommodate signs. <br />D. Proceed with installation only after unsatisfactory conditions have been corrected.