80A - JOINT WORK CENTER MOU - Laserfiche WebLink

Home Browse Search

EXHIBIT 3 EXHIBIT B — OUTLINE SPECIFICATIONS DIVISION 2 For Items that are shown with strikethrough (Mri#ethrouo) please refer to Division 3, Special Provisions for amendments to the requirements. DIVISION 2— DESIGN REQUIREMENTS 2.1 FLOOR CONSTRUCTION AND FINISHES A. Concrete floor: 1. Concrete floor construction is the standard for comparison. Floor of another material may be acceptable provided its use does not produce or transmit sound or vibration to a greater degree than a 4" reinforced concrete slab. a) Lessor shall provide certification that the concrete slab is level and does not exceed a variance of Ya inch in 10 feet from a true flat plane. b) Where slab is out of compliance, leveling shall be achieved using a high - strength concrete topping compound, i.e., Mapei, Ardex, Inc., K-600, Hacker Ind., Firm Fill4010, Maxxon, Level -Right, or approved equal material. 2.Concrete floors in janitor closets, mechanical, and/or electrical utility rooms shall be cleaned and treated with epoxy coating. Office areas throughout shall have carpet or other floor covering with 4" high cove base, unless noted otherwise. Floors in toilet rooms shall be of nonabsorbent material impervious to moisture, such as ceramic He or approved equal, with minimum 4" high cove base. Floor covering shall extend under counters and cabinets. Colors and patterns shall be as selected or approved by State. 3.Prior to the installation of any finish floor material, Lessor shall perform a quantitative moisture test on the concrete slab. The test shall be administered in accordance with the flooring material manufacturer's written guidelines or recommendations. In the event the moisture content exceeds the flooring material manufacturer's recommendation, the Lessor, at Lessor's sole cast and expense, shall provide and install a waterproofing sealer as recommended by the flooring material manufacturer. 4.Exposed concrete floors are not acceptable in toilet rooms, locker rooms or shower rooms. B. Carpet flooring —General: 1. Lessor shall provide and install carpet and cove base where shown in Exhibit "A." All carpet shall comply with American National Standards Institute (ANSI) NSF 140-2007 Platinum level. a) When requested by DGS, Lessor shall submit carpet samples to DGS for selection. The samples shall be from a minimum of three different manufacturers and consist of a variety of patterns, textures, colors and styles. b) Carpet shall have random graphic pattern loop non -generic branded, 6 or 6.6 nylon face yarn with inherent static control. 14 Rev, March 2019 80A-624