KDC SYSTEMS (2) - Laserfiche WebLink

Home Browse Search

equipment has been completed, the Contractor shall perform the following post -installation field verification tests: 1. Site Acceptance Test (SAT) Once system installation has been successfully completed and installed, the Contractor shall perform a site acceptance test (SAT). The Contractor shall test the full operation and functionality of the completed system in the SAT with a City Representative. The Contractor shall provide any rectifications required to complete the SAT. The Contractor shall utilize the form in Exhibit C to complete the SAT and shall advise any additional components that necessitate testing. Once all operation and functionality are confirmed and approved by City Personnel in the SAT, the Contractor shall commence on -site closeout and final completion of the project. 2. On -Site Closeout During the on -site closeout, the Contractor shall review the panel construction drawings for any redlines, changes or corrections that have been added and confirm they match in the field. The Contractor shall confirm all non -conformances have been corrected, re -tested, and signed off. The Contractor shall confirm the UL508 label has been affixed to the panel. The Contractor shall clean and vacuum the panel as well as take detailed photos after installation. 3. In -Office Closeout The Contractor shall redline all changes to the design made during construction and testing on the as -built panel schematics and shall provide all records including photos and schematics to the City upon closeout of the project. 4. PANEL DESIGN SERVICES Upon request by the City, the Contractor shall provide control panel design services that conform to City standards. Control panel designs and drawings shall contain fully engineered diagrams that specify all equipment, back panels, terminal blocks, and special components and related items. The wiring diagrams, specific 1/0, panel dimensions, items and quantity list with specific part numbers shall also be included in the designs. All wiring diagrams shall show all components, including power and control wiring, instrumentation wiring, ground wiring, terminal blocks, and their associate nameplates with terminal block termination designations, identification labels, and wire sizes, types and colors. Panel design documents shall be complete and inclusive of all information necessary for the City to utilize for construction purposes. When applicable all panel designs and schematics shall include, but are not limited to: 1. Table of Contents 2. Drawing Symbol Key 3. Bill of Materials 4. Construction Comments and Special Instruction 5. Control Panel Exterior Detail City of Santa Ana RFP 21-100 Water Resources Panel Building Services Page 19 of 39