NS-240 - Laserfiche WebLink

Home Browse Search

"Section 8224. CoollngWater. "Sec. 609 of s~ d Code is amended by adding a new sentence at the end to read: 'Such water from these appliances, devices or apparatus used in ~ny structure shall not be discharged or drained into any street or alley.'" "Section 8225. Vertical Wet Venting. "Sec. 614 of said Code is amended by substituting for the en- tire section a new section to read: ,Vertical Wet Venting shall not be permitted.'" "Section 8226. Combination Waste and Vent System. "Sec. 615 (e) of said Code is amended to read: 'Unless spec- ifically required or permitted by the Administrative Authority no vertical waste pipe shall be used in any such system except the tail piece or connection between the outlet of a plumbing fixture and t~e trap therefor. Such tail pieces or connections shall in no case exceed two (2') feet.'" "Section 8227. Traps Required. "Sec. 701 (d) distance between outlet shall not of smd Code is amended to read: 'The vertical a fixture outlet ~ d the center of the waste exceed twelve (12") inches in length.'" "Section 8228. Grease Interceptors. "Sec. 711 (a) of said Code is amended to read: 'An approved type grease interceptor complying w~th the provisions of this section shall be installed in the waste line leading from sinks, drains, and other fixtures or equipment only when required by the Director of Public Works, or by the Health Department, in establishments where grease can be introduced into the drainage system or sewage system in quantities that can effect line stop- page or hinder sewage treatment. A grease interceptor is not re- quired for individual dwelling units or for any private living quarters.'" "Section 8229. Grease Interceptor Plans. "Sec. 711 (b) of said Code is amended to read: ,Plans shall be submitted to the Department having Jurisdiction and ~proval obtained prior to the installation of any plumbing system or part thereof designed to include a grease interceptor.'" "Section 8230. Prohibited Joints and Connections. "Sec. 806 (b) of said Code is amended to read: 'No fitting or connection that offers abnormal obstruction to flow, sh~l be used.'" "Section 8231. Size, Rise and Run of Vents and Vent Connectors. "Sec. 1318 (d) of said Code is mended to read: 'Metal vent connectors shall be not less in diameter than the vent outlet of the water heater. Vent connectors shall have a rise of no less tha~ one fourth (~") inch per foot of length. The horizontal projected length shall not exceed seventy-five (75%) per cent of the vertical projected length of the vent and vent connector.," "Section 8232. Independent Vent Required. "Requirement four (4) of Section 1320 of s~ d Code is amended to read: 'Both the vent manifold and the vent connectors shall -6-