NS-793 - Laserfiche WebLink

Home Browse Search

SECTION 8326. Flexible Metal Conduit. Section 350-2 is amended to read as follows: 350-2. Use. Flexible metal conduit shall not be used (1) in wet locations, unless conductors are of the lead-covered type or of other type specially approved for the conditions; (2) in hoist- ways, except as provided in Section 620-21; (3) in storage battery rooms; (4) in any hazardous location, except as permitted in Sections 501-4(b), 502-4, and 503-3; (5) where rubber-covered conductors are exposed to oil, gasoline, or other materials having a deteriorating effect on rubber; (6) where embedded in masonry, concrete, adobe, plaster, or similar finish; nor (7) where exposed to mechanical injury. SECTION 8327. Liqhtinq Fixtures, Lampholders, etc, Section 410-8 is amended by adding a new subsection (c) to read as follows: (c) Ail closets provided with lighting outlets shall have said outlet operated by a wall or door switch (no pull chain lighting fixtures permitted) and the lighting outlet shall be located so as not to be within 12 inches horizontally from or directly over any shelving. SECTION 8328. Liqhtin~ Fixtures, Lampholders, etc. Section 410-29 is amended by adding a new subsection (c) to read as follows: (c) No such equipment shall be installed in which the power factor is less than 90%. SECTION 8329. A~liances. Section 422-2 is amended to read as follows: 422-2. Branch Circuit Requirements. Every appliance shall be supplied by a branch circuit of one of the types specified in Article 210. Motor-operated appliances shall also conform to the requirements of Article 430. Fixed appliances, such as food grinders, dishwashers, washingmachlnes, dryers, laundry tray locations, built-in refrigerators, built-in freezers, furnaces, air conditioners, built-in heaters, or any other fixed appliance with motors 1/4 H.P. or larger shall be on a separate branch circuit supplied by No. 12 A.W.G. wire. Each single family dwelling and each occupancy of a multi-family dwelling shall have installed therein an individual food waste grinder branch circuit. Said circuit shall be supplied with a minimum No. 12 A.W.G. wire and a 15 ampere indicating type switch. Said switch shall be located in the wall adjacent to the sink. Food waste grinder shall be wired with a minimum of No. 16 A.W.G. 3-wire S.P.T.-3, thermoplastic hard finish cord or equal and an approved grounding type cord grip cap must be used. SECTION 8330. Appliances. Section 422-40 is amended by adding a new subsection (e) to read as follows: (e) Approved recessed ceiling heaters using not more than one (1) 250 watt infrared lamp may be installed on alighting branch circuit by reducing the allowable number of lighting outlets by two (2) for each single lamp device used. However, not more than two (2) such devices shall be connected to any one (1) lighting branch circuit. Any number of multiple lamp and single lamp heaters, the total wattage not exceeding 1500 watts or the total number of 250 watt lamps not exceeding six (6), may be connected to a separate 20 ampere branch circuit. -20-