NS-1147 - Laserfiche WebLink

Home Browse Search

(2) Apartment buildings three stories and less in height where building supply is two inches or larger, each building ............................. 15.00 (3) Ail other systems, where building supply is two inches or larger, each building ............................. 20.00 G. Water heater vents, each system ........... 10.00 Plan Check fee for alterations to approved plans, per hour ........................... 12.00 I. Minimum charge, per half hour or less ..... 6.00 SECTION 22: 8-390, and 8-393, hereby repealed. Chapter 8, Sections 8-370, 8-372, 8-374, 8-380, inclusive of the Santa Ana Municipal Code are SECTION 23: The Santa Aha Municipal Code is hereby amended by adding a section to be numbered Section 8-398, Which said Sec- tion reads as follows: Sec. 8-398. Water closet flushing capacity (Section 1001) Section 1001 of the Uniform Plumbing Code is amended by deleting the last sentence. SECTION 24: Chapter 8, Section 8-400 of the Santa Ana Munici- pal Code is hereby amended to read as follows: Sec. 8-400. Water piping in buildings (Section 1008(c) (1). Section 1008(c) (1) of the Uniform Plumbing Code is amended to read as follows: (1) Non-metallic and ferrous piping shall be prohibited; except that ferrous piping four (4) inches and larger may be used when protected against corrosion and in- stalled in channels, tubes or in a similar protective manner when approved by the Administrative Authority. SECTION 25: The Santa Ana Municipal Code is hereby amended by adding a section to be numbered Section 8-401, which said Sec- tion reads as follows: Section 8-401 Building Supply Pipe (Section 1009(h)). Section 1009(h) of the Uniform Plumbing Code is amended by changing the second paragraph and adding a third paragraph to read as follows: (h) Size of meter and Building Supply Pipe Using Table 10-2. Knowing the available pressure at the water meter or other source of supply, and after subtracting one half (1/2) pound per square inch pressure for each foot of difference in elevation between such source of supply and the highest water supply outlet in the building or on the premises, use the "Pressure Range" group within which this pressure will fall. Select the "length" column which is equal to or longer than the required length. Follow down the column to a fixture unit value equal to or greater than the total number of fixture units required by the installation. Having located the proper fixture unit value for the required length, sizes of meter and building supply pipe will be found in the two left-hand columns. -9-