Laserfiche WebLink
o <br /> <br />· Checking operation a.nd calibration of the slide valve <br /> <br />Checking the Compressor Oil System for the following items: <br /> <br />Changing oil, oil filter and dryer <br /> <br />Conducting analysis on oil and oil filter at an independent laboratory <br /> <br />Checking oil pump, seal and motor where applicable <br /> <br />Checking heater and thermostat <br /> <br />Checking all other oil system components including cooler, strainer and <br />solenoid valve where applicable <br /> <br />Checking the Condenser for the following items: <br /> <br />Checking Motor Starter and performing the following tasks: <br /> <br />· Running diagnostic check <br /> <br />· Cleaning contacts or recommending replacement <br /> <br />· Checking linkage <br /> <br />· Meging motor <br /> <br />· Checking all terminals and tightening connections <br /> <br />· Checking overloads, dash pot oil <br /> <br />· Cleaning or replacing air filter where required <br /> <br />· Dry running starter (or before start-up); checking status lights <br /> <br />Review the Control Panel for the following items: <br /> <br />· Running diagnostic check of Micro Control Panel <br /> <br />· Checking safety shutdown operation <br /> <br />· Checking all terminals and tightening connections <br /> <br /> Checking Display Data accuracy and set points <br /> <br />Checking the water flow - --- <br /> <br />Checking flow switch operation <br /> <br />Removing condenser head and inspecting end sheets <br />Mechanically brush cleaning condenser water tubes. <br /> <br /> <br />