Laserfiche WebLink
<br />c. <br /> <br />All cladding shall not emphasize the vertical except at <br />termination points (changes in direction or corners). <br /> <br />2. <br /> <br />Exposed Sub-Elements: <br /> <br />Well-detailed exposed structural steel and H.V.A.C. elements shall be used. This <br />includes the extensive use of painted trusses, spaceframes, metal deck ceilings, <br />track lighting and well-detailed ducting/registers. <br /> <br />3. <br /> <br />Glass: <br /> <br />Extensive use of tinted glass in showroom, office and light-requiring service <br />building areas should be used. Compatible opaque (spandrel), insulated glass is <br />suggested for areas requiring non-vision glazing for continuity of effect. <br /> <br />The glass to be used shall have a bluish tint and slight reflectivity in non-direct <br />auto viewing area. Vision glazing specifications are to be equivalent to P.P.G. <br />'Solarban 570-30 Sapphire Blue' series. No mirror-glass or highly reflective glass <br />may be used. <br /> <br />4. <br /> <br />Wall Claddina - Flat Metal Panels: <br /> <br />Smooth aluminum panels may be used in flat or curved cladding for the opaque <br />showroom and office exterior wall cladding. This also applies to service building <br />cladding termination (ends, fascias, soffits and corners). Quality and trueness of <br />material (e.g., no oil-canning permitted) and workmanship are of the utmost <br />importance. <br /> <br />Panels shall be solid aluminum, and shall be impervious to water, and non- <br />flammable. The panel edges shall be brake-formed at right angles to the frontal <br />plane and all corners are to be welded and ground smooth. It shall provide a <br />front access fastening system which means individual panels may be removed at <br />any time. The thermally dynamic fastening sy~tem shall insure maximum <br />weather integrity. The system shall also include an internal drainage system <br />which directs condensation to the outside of the building. The finish shall be an <br />anodized or Kynar Tri-X metallic finish. <br /> <br />5. <br /> <br />Materials: <br /> <br />a. Panels shall be fabricated from minimum .120 (3.04 mm) thick aluminum solid <br />plate of 3003-H134 or 5005-H32 AQ alloy, in accordance with architectural <br />documents and manufacturer's approved drawings including verified <br />dimensions. <br /> <br />Exhibit "B" <br />Page 16 of 19 <br />758-22 <br />