HARPER & ASSOCIATES 1 - 2004 - Laserfiche WebLink

Home Browse Search

City of Santa Ana Coating, Painting and Structural Inspection Proposal March 15, 2004 paints are evenly applied at proper thickness and with no overspray to interfere with adhesion. 7. INTERMEDIATE & FINISH COAT INSPECTION (EXTERIOR) - After approval of prime coat application, ongoing inspection monitors weather condition, Contractor's application equipment and its operation, mixing of paint and physical inspection of paint application, including spray techniques, cleanliness of surface thickness, etc. a. Procedures outlined in 7. above are repeated during application of additional coatings, including careful examination of areas where cleaning penetrated coating film to verify edges of film have not lifted, curled, etc. Where defects exists, additional cleaning will be performed to bring area into compliance with specification and area will be recoated as required. 8. FINAL INSPECTION (EXTERIOR) -Requires input at conclusion of finish painting to verify application and dry film thickness are in conformance to specification. a. Surfaces would be tested for dry film thickness as noted under 4.a. above. b. Holiday detection is not normally utilized on exterior painted surfaces, so total area would be visually examined to determine complete coverage and compliance with specification, both physically and aesthetically. 9. LIMITATIONS OF AUTHORITY a. Resident Project Inspector: (1) Shall not authorize any deviation from the Contract Documents or substitution of materials or equipment, unless authorized by ENGINEER/OWNER in writing. (2) Shall not exceed limitations of CONSULTANT'S AUTHORITY as set forth in the Agreement or the Contract Documents. (3) Shall not undertake any of the responsibilities of CONTRACTOR, subcontractor or CONTRACTOR'S superintendent. (4) Shall not advise on, issue directions relative to or assume control Harper & Associates Engineering, Inc. proposals~INSP-Santa Ana 1 I