SecSol - Laserfiche WebLink

Home Browse Search

continuous, competent supervision. The completed installation shall display competent work, reflecting adherence to prevailing industrial standards and methods. E. Protection of Equipment and Materials: The CONTRACTOR shall provide adequate means for and shall fully protect all finished parts of the materials and equipment against damage from any cause during the progress of the work and until acceptable by the ENGINEER. F. All materials and equipment, both in storage and during construction, shall be covered in such a manner that no finished surfaces will be damaged, marred, or splattered with water, foam, plaster, or paint. All moving parts shall be kept clean and dry. G. The CONTRACTOR shall replace or have refinished by the manufacturer, all damaged materials or equipment, including faceplates of panels and switchboard sections, at no expense to the CITY. H. Tests: The CONTRACTOR shall make all tests required by the ENGINEER or other authorities having jurisdictions. All such tests shall be performed in the presence of the ENGINEER. The CONTRACTOR shall furnish all necessary testing equipment and pay all costs of tests, including all replacement parts and labor necessary due to damage resulting from damaged equipment or from test and correction of faulty installation. The following testing shall be accomplished: Testing for the ground resistance value specified under "Grounding," herein. 2. Insulation resistance tests as specified under "Wire and Cable," herein. 3. Operational testing of all equipment furnished and/or connected in other Sections of Division 16, Electrical, including furnishing of support labor for testing. Standard test reports for mass-produced equipment shall be submitted along with the submittal for such equipment. Test reports on testing specifically required for individual pieces of equipment shall be submitted to the ENGINEER for review prior to final acceptance of the project. J. Any test failure shall be corrected in accordance with the industry practices and in a manner satisfactory to the ENGINEER. 1.6 AREA DESIGNATIONS A. General: For purposes of delineating electrical enclosure and electrical installation requirements of this project, certain areas have been classified in the Contract Documents as defined below. Electrical installations within these areas shall conform to the referenced code requirements for the area involved. B. General Purpose Indoor Locations: Electrical work installed in areas which are not otherwise specifically classified shall be "General Purpose." Workmanship and enclosures shall comply with the general requirements of these Specifications. Electrical enclosures, other than RTU enclosures, shall be NEMA Type 1. City of Santa Ana Basic Electrical Requirements Security Management System Project Page 16010-3 SantaAna_SMS_16010