Laserfiche WebLink
A. Description: Refer to Section 16123 — Wire and Cable. <br />B. Locations: Each conductor at terminal boards and at each termination. <br />C. Legend: <br />1. Power Circuits: Branch circuit or feeder number indicated on drawings. <br />2. Control Circuits: Control wire number indicated on shop drawings. <br />D. Identification Tape: Identification tape for protection of buried electrical installation <br />shall be a 6-inch wide red polyethylene tape imprinted "CAUTION —ELECTRIC <br />UTILITIES BELOW." <br />PART 3 — EXECUTION <br />3.1 PREPARATION <br />A. Degrease and clean surfaces to receive nameplates and labels. <br />3.2 APPLICATION <br />A. Install nameplate and label parallel to equipment lines. <br />B. Secure nameplate to equipment surface using 316 stainless steel roundhead <br />machine screws. Sheet metal screws shall not be used. <br />C. Wire numbers shall be precisely located on each conductor, 3/8" from end of <br />insulation. Where solderless type terminals are used, the number shall be applied to <br />the wire not the terminal insulator. <br />D. Cast cover plates for switches and receptacles shall be engraved with circuit <br />designations. <br />E. For all electrical control panels, control station, disconnect switches, etc., the <br />CONTRACTOR shall furnish and install nameplates, which shall be black lamicoid <br />with white letters showing equipment name, equipment tag number. The nameplates <br />shall be fastened to the various devices with round head stainless steel screws. Each <br />disconnect means for service, feeder, branch, or equipment conductors shall have <br />nameplates indicating its purpose and its name and tag number. All field devices <br />such as pushbuttons, control stations, instruments, etc., shall have identification <br />nameplates. <br />F. All internal devices control panel, shall be properly identified with permanent tags as <br />described in the schematic diagrams. <br />G. The CONTRACTOR shall install identification tape directly above buried raceway. <br />Install tape 8-inches below grade and parallel with raceway to be protected. <br />- END OF SECTION - <br />City of Santa Ana Electrical Identification <br />Security Management System Project Page 16195-2 <br />SantaAna_SMS_16195 <br />