25J - MEMORIAL POOL - Laserfiche WebLink

Home Browse Search

1. Address cracks, waterprootng, and leakage at the foundation of the fountain and restore interior finish. 2. Install new spray center jet. 3. Provide new lighting for the fountain. 4. Replace electrical panel and plumbing system (including the water pump system) in the existing equipment room. 5. Assess all existing electrical and plumbing systems (including electrical panel) required for the proposed fountain performance. Address all existing electrical and plumbing systems lacking the capability of handling the new systems. 6. Remove and replace the existing concrete coping and sloped cobblestone veneer around the fountain with new materials per the City instructions. 7. Install skate-stopper around the fountain edge. 8. Construct a storage room for chlorine, carbon dioxide, and acid systems (optional design feature). 2. Utility Coordination and Design -All impacted utility lines within the project limits shall be compiled on utility base plans and forwarded to each utility agency for review, correction, and certification of accuracy. Consultant shall copy the City of Santa Ana on all transmittals, notifications, submittals and letters to the utility agencies. Consultant shall coordinate any necessary utility designs with utility agencies. 3. Electrical Design The details of electrical circuiting and riser diagrams, primary wiring and conduit, transformers, and electrical panel shall be drawn on the electrical plans. Consultant shall provide any additional necessary details for construction and operation purpose. Consultant is providing an allowance to subcontract the services of an electrical engineer to provide power to mechanical equipment, lights and control panel for the fountain system. Electrical plans to include single line diagram, load calculations, panel schedule (if needed), electrical site plan, and equipment wiring diagram. Consultant shall coordinate with design team to determine if a pad transformer and service entrance and meter section wilt be required as part of the design. 4. Structural Design -The design of waterproofing and its protection shall be provided for the edges, walls and bottoms of the fountain. Consultant is providing an allowance to subcontract the service of a structural engineer to verify that the footings and walls of the pool and fountain perform in accordance with the current California Building Code (CBC). The structural engineer shall also provide recommendations for the pool edge repair. 5. Mechanical Design - The new pump system at Fountain No. 3 shall be designed to operate fountain center jet. Consultant shall provide details for piping, valves, fittings, pump equipment, and any additional necessary elements. Specifications shall include pumps and piping manifold layouts. Consultant is providing an allowance to subcontract the service of a mechanical engineer to evaluate the ventilation condition in the fountain equipment room and pool building. All other pumps and piping design are included in the tasks above. 6. Plans Preparation -The plan development shall include at least two (2) plan deliverables- 95% (pre-final) and 100% (final). Each project shall be prepared separately under different title sheet. Plans shall be prepared in conformance with City of Santa Ana standards. The necessary plans shall include, but not be limited to: 1. Plan i. Title Sheet ii. Layout and Dimensions (Memorial Pool to be drawn at a maximum scale of ~/s" = 1' and Plaza of the Fountains at maximum scale of/4" = 1') 25J-15