Laserfiche WebLink
PART 2 — PRODUCTS <br />2.01 MATERIALS <br />A. Products specified are as manufactured by the Vista Paint Corporation. All other manufacturers <br />must be equal or better in performance specification. All substitutions must be submitted to Agency for <br />approval. <br />B. Materials selected for coating systems for each type surface shall be the product of a single <br />manufacturer. <br />C. Accessory materials such as turpentine, thinner, and putty shall be of the highest quality and by <br />Agency approved manufacturer. <br />D. Finish coats shall not be thinned without Agency's approval. Sufficient coats shall be applied at <br />no additional cost to completely hide base materials, produce uniform color and provide satisfactory <br />finish result. <br />E. All submitted paint products to be in compliance with all local, state and federal air quality <br />mandates. <br />F. All colors are to be selected or approved by the Agency. All prime coats shall be tinted to contrast <br />the finish coat. The final coat of paint shall not be applied until the Agency has approved colors. The <br />number of colors to be used shall be as determined by the Agency. Agency reserves the right to vary <br />colors throughout the project. <br />PART 3 — EXECUTION <br />3.01 INSPECTION <br />A. Examine surfaces scheduled to receive paint and finishes for conditions that will adversely affect <br />execution, permanence or quality of work and which cannot be put into acceptable condition through <br />preparatory work as included in Article 3.02 "Preparation of Surfaces". The Contractor shall notify the <br />Agency in writing of any defects or conditions which will prevent a satisfactory installation. <br />B. Do not proceed with surface preparation or coating application until conditions are suitable. <br />C. Commencement of painting will be construed as acceptance of surfaces. <br />3.02 PREPARATION OF SURFACES <br />A. All surfaces to receive paint shall be clean, dry, smooth and dust free before application of any <br />materials. Prepare surfaces as follows: <br />1. PRIMED FERROUS METAL: Remove all foreign matter. Touch up abrasions with Vista Paint <br />9600 Protec Metal Prime. <br />2. UNPRIMED FERROUS METAL: Remove all rust, mill scale and foreign matter by wire <br />brushing, scraping, sandblasting or solvent as required to provide a clean, smooth surface. Spot <br />prime with Vista Paint 9600 Protec Metal Prime. <br />3. GALVANIZED METAL: Remove all foreign matter and clean entire surface with mineral spirits. <br />Pre -treat with phosphoric acid, etch or vinyl wash. Apply primer the same day as pretreatment is <br />applied. <br />4. PAINTED SURFACES: Remove all foreign matter, tape, illegal signs etc. Remove all flaking or <br />delaminated paint with approved methods. If existing paint has completely flaked off, bare metal <br />4 <br />